(800) 853-2651
SHOP NOW

Recent content by Peter Fetzek

Yesterday's Tractor Forums
  1. H

    Oh what a reief it is...oil pressure

    My old Massey Ferguson 65 gas was showing low oil pressure, down around 10 psi. It had me worried. I did not want to run it until it went bad. So, I decided to try a new oil pressure gauge and line before pulling the pan and looking for problems. New line and gauge showed 30psi, very steady. I...
  2. P

    tractor accident

    Forwarding arches are nice, if you can afford or fabricate them. You're more trailering a log instead of trying to drag it. Keeps them cleaner. Redistributes the weight a bit.
  3. P

    ol' Dell confesses

    My condolences. I lost my Scosh (she was the runt) a year and a half ago and I still get weepy when I think of her. She was part Maremma & I was her herd... always watching over me, making sure I was ok. They sure have a way of weaseling into your heart. where's the kleenex pete
  4. P

    OT: First Blue Catfish

    Good Job Kaden! What body of water was that? pete
  5. P

    Piece of crap

    Yes. I really think you need to take em out and let them grunt once in a while. IMO one of the best things that happened to my 45 2n is using it to put some food plots in. We'll do the same with the 46 after the carb gets tweeked. pete
  6. P

    46 2n dies when driving on slope

    Hi all- Something cropped up yesterday while using my 46 2n. I was driving on a slope with the left side of the tractor lower than the right by maybe 8 inches or so, when it died & wouldn't re-start. Carb had gas streaming out of the bottom until I turned it off at the tank, leading me to...
  7. P

    Not bad for a free tractor...

    Hi all- Got my son's 2n started this morning. It runs pretty rough, (that might be from the atf he put in the cylinders burning off) but at least it starts and runs. I will replace the plugs later today. About all I did so far is replace the wires and cables, gas shut-off & filter screens...
  8. P

    Have I got this right (ignition circuit)?

    OK I can do that. Sounds like I'm on the right track, then. thanks pete
  9. P

    Have I got this right (ignition circuit)?

    Hi- Please tell me if I'm headed in the right direction. I'm trying to get 3.5 amps at the points for a '46 2n, front mount, 12v system. I have a coil that is 1.5 ohms according to my analog multimeter with fresh battery installed. That, with the OEM ballast resistor, equals 2.5 ohms, right...
  10. P

    resistors

    I'll try to figure out how to send a pic.
  11. P

    resistors

    Hi all- I'm working on re-wiring a '46 2n with a 12v conversion, serial # 216694. Can someone tell me the difference between the larger dia. coil resistor and the smaller dia. one, besides one being about twice the price? There's also an extra part directly below the stater switch. The...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top