Recent content by Peter S

  1. C

    4th of July Parade

    My entry in the local 4th of July parade......we must have had at least 20 tractors there this year and a lot of politicians......
  2. Ed S.

    Independence Day

    es [i:3c399bd7a5]About the Declaration there is a finality that is exceedingly restful. It is often asserted that the world has made a great deal of progress since 1776, that we have had new thoughts and new experiences which have given us a great advance over the people of that day, and that...
  3. B

    Pertronix.....

    I'm having issues with the points burning out fairly quickly on my tractor and I am contemplating on installing pertronix system. I have bought my points from many places with the same results. Does the tractor have to be a 12 volt system to work or can you stick with the stock 6 volt?
  4. R

    1959 541 offset

    Any one know where i can find steering box or rebuild kit.
  5. P

    Looking for parts

    I have exhausted internet search,or missed something along the way. I want a Made in the USA clutch, pressure plate and throw out bearing. Any merchants in your area that I could contact. Thanks
  6. M

    Bryce from Idaho

    I haven't seen anything from Bryce in quite awhile. I just hope he is busy and don't have time. I know he is a very busy guy. Always enjoy his messages.
  7. R

    l10 cummins in a 9000 Ford

    Wondering what kind of oil change interval you folks use for a semi? This one holds 10 gals of oil.
  8. K

    4440 thermostat question

    Hello gentlemen the heat on my 4440 hasnt been working that great on these cold nights. When feeding cattle, the engine just barely gets to the green band on the in cab temp gauge. I recently replaced the thermostats when I was doing an overdue coolant change. Thinking one of them might be...
  9. M

    JD 1020 brake failure?

    I've been cleaning metal out of the rear of my 1020 that my grandfather got repo probably in the early 70's. I assumed all the fine metal that was in the rear came from spider gear failure about 20 years ago and just not cleaned out properly. I removed both axle housings to clean them out and...
  10. tomstractorsandtoys

    Re: Your list of combines you?ve had

    I remember Dad having a Massey 82 and later a Gleaner E,then an E III,3300 Deere and a 4400 Deere. I started out in 1989 with a Deere 45 without a cab when that machine was lost in a fire I got a second 45 and then a third one. When we mover I bought a sharp 95 then a 55 and a second 95 and 105...
  11. G

    Case 480b

    I have a case 480b everything works good.i checked the transmission and it's low can anyone tell me what kind I need to use and how much. I see two(2) places on top of shifter is that the only places to fill. I don't have a service manual. Thanks for any help on thin matter
  12. R

    1952 8N carb

    Here we go folks...I have 12 volt,electronic ign. It was running then died. Carb float is set,new coil,timing set. I have spark to plugs. Switch is working. Try to start and maybe run 5-10 seconds then dies. Tried starting fluid not really any help. Any advice is appreciated. Thanks a...
  13. W

    Lithium Battery Saws

    Looks like everybody has thrown away their corded power hand saws and have gone to Lithium battery saws. Question, What happens to that battery if the saw is only used occasionally? Like 4-5 times a year, but then for several hours or days at a time? I like the size and convenience, but...
  14. D

    Stinky

    Never shoot a skunk in the hen house!
  15. F

    Robertshaw lp gas valve replacement done

    I have the new gas valve working in the heater. The two safety wires coming out of the thermocouple port area needed to be jumpered together to keep the pilot lit. The black flame control knob does not do much. I get the best flame when it is almost wide open. Many thanks for helping me along.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top