Recent content by Peter Taylor

  1. C

    My $125 Co-Op

    This is my $125 Co-op. Ready for the twist? sometime in its life the old motor gave up so the owner ? installed a 1940s- 50s Jeep 2A high hood engine.This motor runs sooo nice, the tractor is not pretty yet but a few fellows have offered me huge prices for just the engine. I told them, you bring...
  2. J

    Re: Reversing the rotation on a generator-How do you do it?

    I think one reason why we hear of soooooooo many VR problems nowadays (including contact material and quality) relates EXACTLY to what you said about the VR needs to be matched to the Gennys Field Current rating. Way back when, Delco Remy made several VR's and they were pretty closely matched to...
  3. F

    did I screw this up??

    Working on replacing the bull pinion (brake) seals on my Farmall M. Managed to pull everything out. 2 seals back to back inside what looks like a tin shim or spacer inside the housing. I wrecked everything getting it out. Do the new seals replace this tin shim, or do I need to replace it and the...
  4. A

    520 - Rear wheel adjustment problem.

    Need to take off the belt pulley to replace the clutch bearing on my 1958 520. But the rear wheel is all the way in and too close to slide out the pulley. It was like that when I bought it 2 years ago. Have followed the instructions in the owner's manual under "pinion and rack adjustment" but...
  5. R

    1957 850 Oil Pressure Gauge

    This may seem like a stupid question but here goes. My 850 didn't have the oil pressure gauge hooked up when I got it. I have a new gauge and am ready to install but I can't seem to find where it connects to the engine. Also, I wanted to change over to a spin on filter. I guess there has to...
  6. B

    M. F. fenders

    I removed a cab from an 1130 and am looking for a good set of fenders and brackets for it. 1080 1100 1130 or 1150 will work. Thanks
  7. A

    hydrolic questions

    I have ford (1972) 4000 3 cyc. Hydrolic's w/ front end loader and 3 pt. hitch skip jump when going up and cannot lift w/ load. Think my hydro. filter is plugged. Steps or other needs to look at to solve problem? How do you access filter? Possible access bye removing cover Plates on left side by...
  8. P

    8N Back Blade swinging

    Is there something that will prevent a 3-point attachment (ie. back blade) from swinging back and forth? My brother thought that there was some sort of stabilizer bars that mounted out under the fender mounts somewhere. Thanks, Phil
  9. P

    3rd Hydraulic Auxiliary Connection Question

    I am a farmer and I have an International 684 tractor. Is anyone aware if this tractor has provision for, or is possible of accomodating a 3rd set or 3rd single hydraulics auxiliary connection, over and above the standard dual set factory supply. I think I have saw a connection ran from the...
  10. P

    International 684 PTO Speeds

    I am a farmer and I have an International 684 tractor. Is anyone aware if this tractor has provision for, or is possible of running the PTO speed at 540 rpm and/or 1,000 rpm? My tractor is a 540 rpm unit, but am looking to see if it is possible for interchangeability to both speeds. Thank you...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top