(800) 853-2651
SHOP NOW

Recent content by Phlash-OK

Yesterday's Tractor Forums
  1. P

    Jubilee

    Engine is stuck now will work on it awhile, see if it will run.
  2. P

    Jubilee

    Thanks Tim, I have a 9N and am familiar with the flathead. I don't know anything about this engine yet, may have to part out.
  3. P

    Jubilee

    I thought it might be an O or 6 or 8. Since it is on transmission housing it couldn't be an 0. My guess is a later 53. Does this make sense?
  4. P

    Jubilee

    Purchased a Jubilee yesterday. Looks like serial # NAA2U914. Can someone help determine year?
  5. P

    Post hole digger stuck now arms wont lift.

    Should be able to chain them up some way
  6. P

    Are you in the market for a compact tractor?

    Son bought new Kubota. Mice and rats did $2000,damage wiring and fuel lines. I have no problems like that with a Ford 9N and Ferg 1030
  7. P

    O.T Butck message

    Have a 2000 Buick, message on panel says gas cap loose,check gas cap. Cap isn't loose. Message stays on. How can I turn it off?
  8. P

    Hydraulic oil

    I acquired 5 gallons of Hydraulic oil labeled Super S AW46. Part #Sus 38. There are no specs. I wonder if this would be good to use in the Ferguson system.
  9. P

    Brake rotors for front wheel weights

    Maybe pictures
  10. P

    Brake rotors for front wheel weights

    Here are pictures
  11. P

    Brake rotors for front wheel weights

    Here are pictures
  12. P

    Brake rotors for front wheel weights

    Used old rotors for weights inside and out This post was edited by Phlash-OK on 03/12/2023 at 03:01 pm.
  13. P

    Lurkers

    Been here for 20 some years, don't post often, have 40 9N Ford, 55T030 Ferguson, 37 GMC,69 GMC. Have received much help from this site.
  14. P

    What was your 1st farm tractor you bought?

    1940 9N Ford. Bought in 2001 , still have,
  15. P

    9N pertronix failure replys

    I have a print out Front Coil Conversion (to standard round coil) by Hobo. It gives details how to gut old Square coil and wire for round coil. I have one on 9N for 20 yes works fine. Have gutted one recently also. I could not find in archives, if you want a copy I could send it to you
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top