Recent content by pinski

  1. P

    JD AR Hydraulic Ram Mount / Display

    Folks Just want to refresh this post. Really hoping someone out there has a picture or more details on where to mount the carrier for the remote cylinder. We still have not been able to figure it out. Thanks Shannon
  2. P

    Propane Tractor - Tank Recertification? - Canada Only

    Are there any propane experts from Canada on these forums? I have a 1965 MM M670 Super with a propane engine. The tractor has not been used in several years but was operational when parked. I am wanting to get it going again, but worried about the propane system. I know for portable propane...
  3. P

    JD AR Hydraulic Ram Mount / Display

    I found the parts breakdown on JD website. See attached, I think that's what you were referring to. I have shown a picture of the back of my tractor. I am at a bit of a loss for exactly where the bracket would mount, but thinking you may need to take out the 2 bolts holding the Powertrol...
  4. P

    JD AR Hydraulic Ram Mount / Display

    Thanks for that info. I do not have a parts manual to see the drawings on page 137. I looked at both part numbers and am struggling to understand where they would mount. Could you send me the diagrams from the manual. Thanks Shannon
  5. P

    JD AR Hydraulic Ram Mount / Display

    Hello everyone. I have the original Power Trol hydraulic cylinder for my 1952 JD AR. Now that the tractor is restored and not used for farm work any longer, I am wondering if anyone has some creative ideas to mount the ram somewhere / somehow on the tractor for display? I’d like the...
  6. P

    AR Governor

    Awesome info. Can you share a bit more detail? Do you have to open up the governor to get to that hole? Thanks
  7. P

    AR Governor

    Well folks, I have my 1952 back up and running. Thanks to all on this forum who have provided assistance. But I am having one small problem. It appears the governor is not functioning properly. The tractor starts and runs well, but the governor does not seem to want to do its thing and limit...
  8. P

    Yellow Paint?

    It is green
  9. P

    Yellow Paint?

    Folks, another question on my 1952 AR restoration. As we clean off all the years of grease buildup, we are finding small bits of the green paint flaking off in some spots. Underneath we are finding yellow paint nearly everywhere. Is this normal and expected? Did they prime coat the tractors...
  10. P

    JD AR Parts

    Good call. I shall be attending an auction, its definitely close enough. Thanks Shannon
  11. P

    JD AR Parts

    I'm in Beaumont. That tractor at auction appears to be in too good of condition to be a parts tractor? Thanks
  12. P

    JD AR Parts

    Just wondering if there is anyone on here that has a John Deere AR parts tractor. Mine is a 1952. I am looking for a good upper cast coolant pipe, coolant drain plug and gear shift lever knob. Could also use a couple battery trays and 8" brackets crews, but i doubt anyone would have any less...
  13. P

    John Deere AR Seat Slider Assembly

    Thanks Dan, that a perfect picture. Here is a picture of mine. It appears I have an extra bend in mine that prevents it from moving as far as it should. I'll get it in the vice and get rid of that second bend. Thanks Shannon This post was edited by pinski on 02/21/2023 at 05:04 pm.
  14. P

    John Deere AR Seat Slider Assembly

    Does anyone have any good pictures of the release mechanism and slider assembly for the adjustable seat on a 1950-53 JD AR? My lever appears to have 2 bends in it and it does not move the pin far enough to allow the seat to slide. I can make it work by adding some washers as spacers, but I...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top