Recent content by Plumbroke200

  1. P

    Electronic ignition/ timing advance

    delco 1112 623 1L16 distributor
  2. P

    Electronic ignition/ timing advance

    John Deere 2010, my timing advance is rusted and spings are weak so it doesn't move freely. I am considering converting to electronic ignition, if I do does the timing advance still need to be fixed of does the electronic ignition bypass the timing advance? Can I buy just the advance/ springs or...
  3. P

    Pistons for 641

    Rebuilding a 641 and the current pistons are 3.55 inch, way oversized no sleeves. Needs bored 10 or 20 thousands but are any replacement pistons/rings available for this size? I realize I could bore it for the oversized sleeves but would prefer no sleeves. Any options?
  4. P

    550 back fires

    Thanks all, changed cap, plugs, points and rotor. As bad top of rotor was I am suprised it ran at all.
  5. P

    ford 6000 parts cd

    Can you list a web site I can't find the parts book on the NH website. But then I am a little slow ;)
  6. P

    550 back fires

    Ordered a tune up kit point cap ect. figure its due since I started it two years ago after sitting for a couple years and didn"t do anything but replace the battery and repace the sediment bowl the previous owner had taken off. thanks
  7. P

    550 back fires

    It has been cold
  8. P

    550 back fires

    Ran fine before being parked for a couple months so I don't see how it would have cracked but I will look at it this weekend. Thanks
  9. P

    550 back fires

    Battery went dead on my 550 and it sat for a couple months. Finally got around to it and put in battery - during that time carb float must have stuck and tank drained dry. Filled it up and it starts but runs rough and backfiring a lot. I can"t think of any reason the battery would cause this so...
  10. P

    This the right area to talk about a Jubilee ?

    Does that mean i will get away with asking 641 questions also? They will probably start soon when I get a chance to work on it. Mike
  11. P

    8N vs 641

    bought the 641 now it will be three weeks before I can play with it since I am traveling. Thanks for the inputs. It doesn't have the three point arms, any idea what model arms will work on it and best way to find some? mike
  12. P

    8N vs 641

    I just bought an old 8N with a non- mounted loader in rough shape and soon after I bought it I came across a 641 in comparable condition. I am leaning to the upgrade as the cost of both was really cheep and I won’t get hurt either way. With power steering and live hydraulics I thought the 641...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top