(800) 853-2651
SHOP NOW

Recent content by PullingWC

Yesterday's Tractor Forums
  1. P

    d17 ignition

    CBS Performance out of Divide, CO can help you gat the right ignition, their number is 800-685-1492
  2. P

    Pullin' Tractor Names 2008

    I also have a pinup girl on mine and it's called Ms.Behavin'
  3. P

    25-40, or a 30-60? Allis E

    Norm Meinert phone number is 815-865-5372 but I think he doesn't want any calls on sunday.
  4. P

    pertronix ingintion question

    I use CBS Perormance out of Divide CO. A bunch of good guys and very willing to help out both in getting the right one and technical question.
  5. P

    tires wanted

    There is a set in the S.I Trader in Beckemeyer for $800 I'm thinking it be a set Andy has.
  6. P

    allis b serial number

    The serial number is to the rear of the gear shift it will start with the letter B
  7. P

    wd needs more power

    I run a 1939 wc with a E motor all it has is the 4 1/8 pistons in it very strong . Horsepower is not yhe only thing knowing how to read a track is the trick. I run 3500 to 4500 super farm and mod and I'm in the top 3 all the time...
  8. P

    overhaul kit WD 45 Diesel

    They have then for sale on here in the engine kits just look uder WD45 they are the last ones listed. I ordered a overhaul kit early this year good parts and fast shipping.
  9. P

    pull date

    The dates are May 24 & 25 Saturday weigh-in starts at 2:30 pull at 4:30 Sunday weigh-in starts at 9:30 pull at 12:00 for more info call Craig at 618-526-2379
  10. P

    wc puller

    If you want to use a WD45 crank you would be better off using the rods and pistons to. The flat tops might give it a little to much compression making it hard to start.
  11. P

    i need a step for allis B

    Steiner Tractor parts has one it sells for $60
  12. P

    D17 head reassembly

    The oil shield, then thighten the rocker shaft down check vavles,vavle cover,rubber washers,flat washers then the last 4 nuts.
  13. P

    Middle of wd45 engine rebuild...need help!

    I just got done overhauling a D-17 motor same problem,Firet thing I did was to remove the middle bearing just leaving the outside two torque them down and check if the crank turns if so take your crank and bearing back to the shop you had grind it and have them up the middle up. If that does not...
  14. P

    Electronic Ignition

    Yes the Pertronix are not cheap but in the long run the cost of point and condensor, foiled plug its worth it I run it in my pulling tractor but also in my grain truck and other tractors on the farm. The grain truck was good for a set of points every two years ,also it run smoother now and a...
  15. P

    HELP ON RULE INTERPRETATION

    USAP says no front cut on super farm stock ,that is no front cut of the bar on the tires. Top cut is on top ,front cut cut is front or some may say full cut tires .
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top