(800) 853-2651
SHOP NOW

Recent content by R Kroch

Yesterday's Tractor Forums
  1. R

    1850 diesel orbital power steering motor

    I had the same problem on my 1850 What I did, I modified a tilt steering column frame from a 2-155, but used a open center motor from a TR 86, it was a Char-linn, Made the tilt work first than plumbed in the new line. Best thing I did
  2. R

    1850 FWA

    You don?t have to pull tub off just cut out a square piece to the front to split transver case.
  3. R

    4640 hyd orbit motor problem

    Yes there is a flow control on left had side. It is set at 2:00 position. Tried to slow down but when I switch it over to the fan on the airseeder tank, I don't get enough RPM. Could try again I guess.
  4. R

    4640 hyd orbit motor problem

    No close centre, JD valve. 725 loader.
  5. R

    4640 hyd orbit motor problem

    I thought it was left valve? Going to grab operator book!
  6. R

    4640 hyd orbit motor problem

    One thing I forgot to mention the 3ph goes down when tractor shut off. Problem happens if 3ph is up or down. Scv's check out okay same as mid mount hyd valve. When you cycle the loader up and down, it also starts to chatter after the third lift, so it's losing the make up oil some where. The...
  7. R

    4640 hyd orbit motor problem

    No flow control valve just on/off. Basically running a Cesna orbit motor on the load auger to fill seed or fertilizer into airseeder tank.
  8. R

    4640 hyd orbit motor problem

    I am having a problem running a hyd auger motor from chattering have to run engine at 1600 rpm. I am on left scv, filter is new, screen in transmission is clean. Gasket and springs in filter return housing good. This 4640 has a loader joy stick valve 3 scv's and 3ph. It will run orbit motor...
  9. R

    6601 Pull Combine question

    We use one, I would take both duals off tractor for better turning, opening the field and getting close enough to grain truck. Around here people that use one Swath the grain for better dry down. Check youtube on 6601 a few good videos on them.
  10. R

    4640 pto ctutch

    You could take the flywheel and clutch in to dealership to adjust. Just mark it so it goes on same way. Remember change rear engine seal too. I would also change the gasket that the engine seal goes in to also, glue it good to the oil pan. There is a special tool for the engine seal also, just...
  11. R

    Sound Guard cab on New Generation JD

    Buy 4230 cheaper in long run.
  12. R

    Loader tractor Let the talks begin!

    John Deere loader tractor
  13. R

    Loader tractor Let the talks begin!

    No twine. What do you think of this loader tractor combo?
  14. R

    Loader tractor Let the talks begin!

    It's a IH 2250 loader.
  15. R

    Loader tractor Let the talks begin!

    Can you post a picture or two please.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top