(800) 853-2651
SHOP NOW

Recent content by railroadgoat

Yesterday's Tractor Forums
  1. R

    ID H or M Farmall Hood

    I have a nice hood off of a Farmall. It is either an H or an M. How can I tell which it is?? Measurements??? Thanks from a forgetfull ole man.
  2. R

    9N 2N aftermarket front wheels 16

    Are these front rims aftermarket from Sears, Firestone, or ??? Wide bolt pattern for the 9N or 2N.They are 16 inch with the center riveted to the outer wheel. What is the value on a pair of there ???? Have a pair of BF Goodrich 5.50x16 to put on them, right size ??? Thanks
  3. R

    300 6 or 12 volt ??

    1956 Farmall 300, Is it 6 or 12 volts ????
  4. R

    Farmall 300 Wheel color ???

    1956 Farmall 300 Row Crop. What color do I paint the front and rear wheels ??? Thanks
  5. R

    Farmall 300 RC KEY

    I need one or two keys for the Farmall 300 Row Crop. Where can I get them ??? Thanks
  6. R

    Welding top link on rear end????

    Top link on my 8N was torn loose by a tree falling on tractor. It is attached by about 2 inches, rest is sprung up away from rear housing. What is the best way to have this welded up ?? Special rod or ???? Thanks
  7. R

    LA

    Rusty Acres Tractor Parts I just picked up an axle and bearings for the rear yesterday. John has almost everything, parted out 66 L series so far he says.
  8. R

    LA carb right?

    Tractor has electric start and lights. Everything hooks up correct ??? Thanks
  9. R

    LA carb right?

    I have a 1946 LA and it has a TSX 147 carburetor on it. Is this original for this tractor ?? What kit will fit it ?? Thanks Still looking for radiator and fan assembly.
  10. R

    LUC parts fit LA block

    Melanie at Sharp's says they do not carry the fan assembly. Tried them last Friday. Thanks
  11. R

    LUC parts fit LA block

    Will the crank, cam, main bearings, rods, pistons, and valve train FOR SURE fit from an LUC into a LA block ??? Are the valve seats and guides in a LA block replaceable?? I need radiator, core or whole, and a fan assembly, either new or used. WHERE can I purchase them ???
  12. R

    LA engine partially stuck

    2 cylinder one's at that !!! 10-14 hp I don't even know that YET.
  13. R

    LA engine partially stuck

    OK fellows. First off YES, I can more than afford a gasket set, just wishful thinking I'd get away without it. Done lots of car engines without pulling heads even after 20-30 years sitting. Problem with this one was: 2 exhaust valves rusted shut. Tractor sat outside some 20 years, without...
  14. R

    LA engine partially stuck

    Flathead engine with valves in the block.
  15. R

    LA engine partially stuck

    Yep, have the plugs out. Still doesn't help. Was hoping to avoid pulling the head as a new head gasket from Deere is $90 total. Thanks
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top