(800) 853-2651
SHOP NOW

Recent content by Randy Shoe

Yesterday's Tractor Forums
  1. R

    What I did today

    What the hell u doing putting this on this tractor site.
  2. R

    Zenith Carb Fill Needle Sticking

    Chances are the needle needs a new seat. could be the sticking problem.
  3. R

    F14 rear rim 40"

    I believe the 38" cast center rims on an F12 will fit the F14.
  4. R

    930 with 504 sleeves and pistons?

    Years ago I put over size sleeves and pistons in a 1030 hoping to give it more HP. Turned up the fuel and until I put a turbo on it i couldn't tell much difference in the oversize kit versus standard. It just needed more air. The turbo made a great difference. Just what I found out by personal...
  5. R

    1960s 14T squarebaler slipclutch

    A new slip clutch will cost more than a 14T is worth. They are not much of a baler. A decent older New Holland 281,282, 283, 268, or even an old 78 make good bales and have 3 times the capacity and a person can pick one up pretty cheap. If you're stuck on JD, an older 466 or 467 are not bad...
  6. R

    john deere 7520

    Had a neighbor that had one in the early eighties. I was told by him it was hard on clutches and didn't have the HP needed for a tractor of it's physical size. He got rid of it for a 4x4 case and had good luck with that tractor.
  7. R

    Miller Bobcat worth

    $2K is exactly what I was thinking it would be worth. And by the way they are the top of the line of portable welder generators.
  8. R

    F 12 project

    I've had problems with both my 37F12 and 37F30 popping and back firing and in both instances it was a bad plug. For the cost I'd start there.
  9. R

    H bearings

    Should be stamped on the insert what it is now but before going back together with It I sure would have the crank ground and then order the bearings.
  10. R

    Plow Day Pics

    The antique pulling club I belong to has a plow day every spring. The guys have every type of plow ever made. What a mess of the field we make as most of the plows and which is common use here in southern Idaho are two way roll over plows, but some of the guys bring one way plows dropping into...
  11. R

    37 F30 puller

    Our little pulling club members have quite a few olivers. There's none you can see in the pic but one of my favorite a guy has that is an exceptional puller is a supper 88. A sweet tractor. Another guy has a 36 model hart parr, I forget the model # but it pulls really good in the 5000# class also.
  12. R

    37 F30 puller

    My old F30 just hasn't been beat in it's class.
  13. R

    Farmall m value

    An M in that kind of shape is worth no more than scrap price and scrap price is extremely low right now. Not much of anything. Would be worth more if parted out.
  14. R

    720 front end loader

    Not sure but I think it depends on whether your tractor has an open or closed center hyd system. You guys that know more about it correct me if I'm wrong, and believe me I've been wrong more than I'm right. LOL
  15. R

    Prayer request for Puller H.B.

    Prayers expedited his way for a full recovery.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top