(800) 853-2651
SHOP NOW

Recent content by rdmytro

Yesterday's Tractor Forums
  1. 4

    JD elevator

    I have run out of shed space and now my elevator has to set out. It prob 50 years old and never has been out in the weather. I oiled it down with used motor but was thinking I could cover it with some tin zip screwed to top on trough? Any one do this or have a better idea? Thanks
  2. T

    sickle mower

    my ford 501 14-92 seems to have a permanent arch built in to the cutterbar. i have the knife out and all the guards off, and it has a couple of inch arch to it. i'm worried when i get done rebuilding it, the knife won't slide well. any thought? can it be straightened/how?
  3. R

    Sigourney IA

    what is the web site for pull information
  4. F

    Deere Offset Plow with Discs

    I am looking for a housing for an old 50's model John Deere offset plow. The part number is DT-5-W. It is the housing for the bearing. Please emai me if you have one or know where I may get one. Or any tips on repairing it??
  5. R

    No Spark

    The voltage at all of the locations battery, ignition, coil +, coil-, and points is 12.14. I noticed that the rotor wasn't seated on the shaft. I removed the rotor and noticed that the rotor flat spot was worn. I reinstalled the rotor and distributor cap, and cranked the engine. I removed...
  6. R

    No Spark

    I ran a wire directly to the points. Still no spark. When the wire shorts does that cause the coil to fail, and need to be replaced? The coil was warm to the touch when a I removed it.
  7. R

    No Spark

    I have a 8N with side mount distributor and a 12 volt system. Yesterday, I was using my tractor to cut a field. It ran fine for 3-4 fours, and then it just stopped. I checked to see if I had a spark, and no spark. I bypassed the ignition switch, still no spark. I changed the coil. I cranked...
  8. R

    Buying a 165

    Thank your for your help. I will go take a second look at it, and go through your checks. Overall have you been happy with your 165? I looking to use it for hay and moving lumber. I will probably do a little bit of plowing and planting too.
  9. R

    Buying a 165

    It has both multipower and power steering. In addition to power steering, what else should I check?
  10. R

    Buying a 165

    I'm thinking of buying a MF 165. Everything seems to working correcting hydraulics, loader, and it starts and runs nicely. Is there anything I should look for on this model tractor before buying? What are problems with this model tractor as it gets older?
  11. R

    Rubbing Tire

    I couple of years ago I put 6.0 x 15 on the front wheels of my 9N. Then, left tire began to rub on the axle. It does not wobble. It makes consistent contact with the axle. However, the right side has a couple of inches of clearance between the axle and the tire. I figured that I had a bent...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top