(800) 853-2651
SHOP NOW

Recent content by Red Rex

Yesterday's Tractor Forums
  1. R

    Wheel leak

    Stoxbill you are correct. Jim, thanks for your reply
  2. R

    Wheel leak

    Hydro filled tire with tube is leaking. New rim or can it be fixed with a new tube? If moved fluid leaks out of the bottom lug.
  3. R

    Multi power transmission swap for standard

    1968 135 diesel. Is a swap to a non multi power doable? are there any multi power parts that can be used with non multi power? Will the main hydraulic pump be different between the 2? Thoughts and comments?
  4. R

    MF 165 oil leak

    THANKS!
  5. R

    MF 165 oil leak

    Thanks! It is definitely the valve cover gasket. Another question, how to tell which 4 cyl diesel is in this tractor? The plate on the intake is not readable
  6. R

    MF 165 oil leak

    New to me 1969 model diesel. Got oil leaking from 2 studs holding the back 2 injectors. What might be the cause?
  7. R

    66 4000 spewing hydraulic oil from pipe

    Alan, did you resolve this?
  8. R

    Ford 4000 hydraulic leak

    it’s not scratched below the portion where the clip fits, but the groove where the clip fits goes have some on the lower lip
  9. R

    Ford 4000 hydraulic leak

    Wire clip is there, the gap is showing in the picture. Backup rings? Schematics on Medsics shows upper and lower o ring with a half moon wire clip on the end that fits into the pump housing. Is that c clip ring supposed to go down into the pump housing?
  10. R

    Ford 4000 hydraulic leak

    Replaced the lower o ring on this pipe. No leaks from the top. What could be the cause of this leak? Failed pressure relief valve? Pipe goes from pump to flow control valve
  11. R

    Sealant

    Thanks
  12. R

    Sealant

    Sean, it is a 1968 ford 4000 3 cylinder
  13. R

    Sealant

    Looking for recommendations on a sealant to use on the threads of the diesel fuel tap where fuel feeds out of the tank to the filter.
  14. R

    Pump cover

    Have a clymer manual. What other one do you recommend?
  15. R

    Pump cover

    I can get the tube to push up but cannot get it to go down past where the clip goes. Clip not installed. If I have no o ring on the bottom will it push down far enough to change the top?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top