Recent content by restingrelics1

  1. R

    cylinder wear

    Dave, Another easy way is to install a new ring in the bore and measure the ring gap. If I remember correctly it suppose to be like 3to5 thousands per inch of bore. You can check that in the IT service book. Of course you will need to have a new ring and be able to return it if you need to...
  2. R

    Model A clutch bearing

    Hi Steve, It's not a big job compared to say rebuilding the engine but a fair amount of wrench twisting is required. You'll need to take the clutch completely out. This a good time to replace the linings while your right there and look over the drive hub for cracks and make sure it's...
  3. R

    John Deere 310C water problem

    Jim, I think you've got a problem with compression getting into the cooling system. Usually a head gasket but you could have a cavatated sleeve or worse a crack somewhere in the head or block. Try running with the raditor cap loose. If after a short while it blows out the coolant you can...
  4. R

    A water pump

    Thanks Jim, One last thing. Do you see the part number for the retaining snap ring that positions the bearing in the housing. The old one is real rusty. I,m not sure I could reuse it. Again thanks for your help. John
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top