(800) 853-2651
SHOP NOW

Recent content by RHBrown

Yesterday's Tractor Forums
  1. R

    John Deere B weight

    I have a late 1948 styled B we were able to get down to the 3500 pound class and it does quite well. We did the usual ie; pressed wheels, flat back with pto we fabricated brackets with angle iron to fit the seat but we also found out if we took the front pedestal off from a 39 or a 40 John...
  2. R

    John Deere gasket

    Appreicate all the feedback, I now have number I"ll call my son he lives fairly near a JD dealer I have him order it. Thanks again
  3. R

    John Deere gasket

    I suppose I could make a gasket, I"m not that good with my hands I have arthitis which makes it difficult for me to follow a pattern. Besides, I don"t have the old gasket to make a template which would make it much easier for me to cut out. Thanks
  4. R

    John Deere gasket

    I am looking for the large gasket that goes between the block and crankcase on a 1945 John Deere A. I don"t live close to a John Deere dealer and I have looked on the web with really no luck. Any information would be much appreciated. Thanks
  5. R

    T-Shirt Logo

    I am looking for a web site that prints logos on T-Shirts. Iv"e looked at several they either want me to order a case or just too difficult to order or to make up your own logo. This is for tractor pulling for both my son and I. A good XMAS present. Thanks
  6. R

    John Deere 2750

    My son just completed rebuilding the bottom end of a John Deere 2750 diesel. He is having a problem with the head the old one is "junk" He got a used head through the web yet it does not fit even though the the number check out. This tractor is a 1982 model 2750 yet the the engine cast no 239T...
  7. R

    1950 B no compression in one cylinder

    A few years ago I was at a tractor pull with my 1948 John Deere B it did the same thing as you just described. After checking as much as I could I checked the petcocks and the one on the pulley side was open! Problem solved... Good Luck hope it turnes out this simple.
  8. R

    dual ex on g

    I stand corrected in front of God and country, your right he did not have dual exhaust.
  9. R

    dual ex on g

    It has been done. Uncle Buck, whom I had the pleasure of knowing, ran one of the hottest Gs you would ever want to watch. Not only did he have dual exhast he had dual carbs also. You can watch him on youtube. Unfortunetly he passed on this winter he will be sorely missed...
  10. R

    JD model B multiple fluid leaks

    I have several old John Deere Two bangers, and not a one of them doesn't leak. Think about it, the two cylinders are banging and rattling all the time and some of them are well over 70 years old now and still running. True, maybe as stated in an earlier post about American made stuff leaking...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top