(800) 853-2651
SHOP NOW

Recent content by RickW

Yesterday's Tractor Forums
  1. R

    Building a Super M puller with a V-8

    I talked with Darren and I think that I am going to buy the full assembly from him. Thanks for the help.
  2. R

    Building a Super M puller with a V-8

    V8 class up to 500 cu. in. 5000 t0 6000 pounds. 6000 max RPM
  3. R

    Building a Super M puller with a V-8

    I am in the process of building a Super M Farmall with a 454 for pulling. What type of clutch and pressure plate do I need to purchase and where can I find them
  4. R

    Tractor Pull Monroe NC , Funderburk Farms

    I would like to challenge all local pullers to come out on the 27th. You guys really put on a great pull and I appreciate the moral standards that you have set. Great place to take the family on a Saturday. Especially if some of the big boys will let me win.
  5. R

    Thanks ,Funderburk Farms

    Great pull. Had a ball and really enjoyed whipping Jimmy T. twice. sorry, just had to say it.
  6. R

    Super M won't take throttle

    Someone sent me an e-mail advising me to close the gap on my plugs and it cured the problem for now. I plan to install a MSD box today to help correct the problem so that i can open the gap back up on my plugs. Thanks to all for the great suggestions and your assistance in this. I really do...
  7. R

    Super M won't take throttle

    i have a Super M puller with around 400 cubes. I have pulled it for 2 years and never had a problem. Now it sputters when you give it the gas quickly or when the govenors kick in. I have replace the plugs, the spark plug wires, the coil and have put another carb off of a 450 on it and nothing...
  8. R

    case 222 cuts off when it warms up

    Serial #9681138. It has a Kohler 12 Hp K301A motor.
  9. R

    case 222 cuts off when it warms up

    Here is an update. I changed the coil, the condensor, I set the gap to 20 on the points, i also changed the wire from the points to the coil. I went ahead and put a new spark plug and a new spark plug wire. It will still crank good, it runs around one minute and it cuts off like it has a direct...
  10. R

    Case 1030 comfort king Timing

    Thanks for all of the advice. Got it done and it runs great and does not leak anymore.
  11. R

    case 222 cuts off when it warms up

    I have a Case 222 lawn mower. It cranks and runs great, but quits in a few minutes when it gets warm or hot. I pulled out the plug and grounded it to the motor and it doesn' have fire. After it cools it will crank fine and run for a minute or so. I changed the coil and that did not help. Any...
  12. R

    Case 1030 comfort king Timing

    I changed out the o-rings on the fuel pump and i thought that i lined it back up correctly. I must have missed it one knotch. The tractor runs fine, but under load it seems to pull down easily and it smokes a little more than it did. It also seems to run a little hot. How do i know how to set...
  13. R

    1030 Case Comfort King Fuel Pump/ block leak

    Very helpful. Thanks for taking the time to respond.
  14. R

    1030 Case Comfort King Fuel Pump/ block leak

    I have a 1030 Comfort King Diesel that is leaking oil where the fuel pump mounts to the block. Can someone give me step by step instructions on how to replace the o-rings without screwing up the timing or the fuel lines. Will i need to bleed the lines once complete?
  15. R

    Super M Puller won't take throtttle

    A little more info. It has a gate valve with a 3/8 line and an in line filter. It also has been stroked and bored. I disconnected the gas line and the carb and it is flowing fine. Also new Autolite 386 plugs with a 35 gap. It also has a hot coil.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top