Recent content by rjpreuss

  1. R

    460 hydraulic problem found

    In response to an ad I posted yesterday, I found my hyd. problem. A pilot pin worked its way out on the main pump, fell between the pump gear and drive gear, wedged itself between one of the pump bolt heads and the gear, and broke off the bolt head while cracking the pump housing. I hate to...
  2. R

    farmall 460 hydraulic question

    I was working with my 460 doing loader work when suddenly I lost almost all hydraulics to the loader (lift and tilt bucket at the same time). The loader will barely lift or tilt now. Did I lose the pump?
  3. R

    O.T. Seven Legged Calf

    I had a neighbor back in the 70"s that had a cow that gave birth to a half cow/half deer. It made major tv networks. They said it met up with a studly buck in the pasture. I believe it only lived about 6 months.
  4. R

    New Holland bale wagon

    I have a model #1034 with some issues. I just purchased this spring so am in the learning process. I think my problems are hydraulic. Two big problems: #1: the pickup chute hydraulic motor is hard to keep running. When engaging the drive from the tractor, there seems to be a "sweet spot"...
  5. R

    New Holland Bale Wagon

    Does anybody know anything about a New Holland bale wagon (model #1034 in particular)? I am having issues. Thanks.
  6. R

    baler problems

    There's no way of adjusting the twine individually. I just think it's unusual the twine length seems to be so much longer right after a tie. And that happens to be the side my bales go long. Thanks for the reply. I sure do appreciate the help offered here.
  7. R

    baler problems

    Yea hopefully that will happen during the CURRENT growing season!!!!!!!!!!
  8. R

    baler problems

    OK I will see if my bales has these. Thanks
  9. R

    baler problems

    Is it possible to just add tension to one side (or are you talking about the crank tensioners on top of the bale chute where the bale is ejected?
  10. R

    baler problems

    I have been running some pretty heavy windrows. Pushing the baler to the limits without shearing flywheel bolts (knives are sharp and set up close). I have not scales the twine, but after a tie i check tension (after a couple of plunges takes the knot off of the bill hook) and there is a very...
  11. R

    baler problems

    New Holland 310 baler question. Bales are not square. Longer on left than right (as you look at the bakc of baler. Tried adjusting tensioners. Tried adjusting finger stroke (further into bale chamber and away from). Adjusted back plate of bale pickup chamber (behind fingers). Nothing...
  12. R

    1034bale wagon problems

    Two problems I am facing with my NH 1034 stackliner: #1: rolling rack does not move back enough to keep up with second table (by the third tier of 15 bales I have to manually move the rolling rack back some, and #2:the load chute chain speed is too slow and hard to regulate. when lever is full...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top