(800) 853-2651
SHOP NOW

Recent content by ROK

Yesterday's Tractor Forums
  1. R

    Wiring problem with John Deere 2940

    I need some information regarding the insertion point for the handbrake signal wire on my John Deere 2940. Due to a recent encounter with some very deep mud, the wire from the handbrake came loose from the end that connects to the wiring harness. I have no idea where that may be. Any ideas?
  2. R

    NAA Carburetor

    The needle that I adjusted is the small one. My book says to close it down, open one turn and turn back until the tractor runs rough. When I turn it back nothing changes. I can close it all the way down and still nothing happens
    • ROK
    • Post #1
    • Forum: Ford
  3. R

    NAA Carburetor

    I have a TSX carb on my NAA. I attempted a rebuild a few years ago. I recently have had backfire problems and tried to adjust to carb needle for gas flow. I closed it all the way, but the engine kept running. It won't shut down and it seems the adjusting needle has no effect when turned. Could...
    • ROK
    • Thread
    • Replies: 4
    • Forum: Ford
  4. R

    Ford NAA

    Thank you for the suggestions. I was putting up hay and couldn't get back to this problem until last night. The points are correctly gapped and I cleaned them. No luck. I tried to test voltage along the way. I have 5v from the battery to the neg. terminal of the coil. Nothing from the coil to...
    • ROK
    • Post #1
    • Forum: Ford
  5. R

    Ford NAA

    I recently posted a message. I indicated that the NAA had no power and was blowing white smoke. The consensus was a bad head gasket. I found no coolant in the oil,so I thought I should search further. I found the rotor to be reduced in length and the points had disintegrated. What was left of...
    • ROK
    • Thread
    • Replies: 4
    • Forum: Ford
  6. R

    NAA

    Thanks for the input. I"m going to check the fluids to see if there is any oil in the coolant, etc. I suspect that I will be replacing the head gasket.
    • ROK
    • Post #1
    • Forum: Ford
  7. R

    NAA

    I am having engine problems with my ford naa. It suddenly has no power. The engine won't produce enough rpms and stalls under a load. I may have had some bad gas, but I emptied the tank and the lines. The spark plugs were wet when I removed them. The engine is blowing white smoke. Any ideas?
    • ROK
    • Thread
    • Replies: 3
    • Forum: Ford
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top