(800) 853-2651
SHOP NOW

Recent content by Ron in Mn.

Yesterday's Tractor Forums
  1. R

    Dresser td8h clutch brake adjustment

    Turn it in snug then back it out half a turn an lock it.
  2. R

    D-17 Hand Clutch Jumping out of High Range

    Assemble the whole works and install back into tractor and then get in touch with me and I can tell you how to adjust it. email me and we can exchange phone numbers.
  3. R

    cockshutt engine

    how do the cam bearings on the 152 & 230 budas get there oil, no guessing know ??? RON
  4. R

    Power steering car to tractor

    I saw somewhere (think it was here) that you can put the electric power steering from a Saturn car on your Farmall B tractor to make it power steering. Has anyone else heard this or know who posted it? I would like to read more on it. Thank you, Ron
  5. R

    Case 450 dozer track loose

    It is probably a 2504 ih w/ an ih loader & an a12or15ftih back hoe. hope this helps, RON
  6. R

    IH T-340 brakes

    The T340 HAS DISC BRAKES ,YOU REALLY NEED A SERVICE MANUAL RON GOOD CRAWLER
  7. R

    Replacing a clutch on a 3414 gas.

    YOU ARE ON THE RIGHT TRACK THE TRANS./ENGINE COME OUT THE BACK
  8. R

    2005 Ram 2500 HD Factory Trailer Tow Wiring

    THANKS FOR All the info. on trailer wiring RON
  9. R

    2005 Ram 2500 HD Factory Trailer Tow Wiring

    Where can I find a colored wiring diagram from the trailer connector to the truck wiring. 4-pin and 7-pin
  10. R

    Difficulty removing HD3 starter?

    Remove both side panels under fuel tank and theirs the starter,disconnect batterys and good luck !!! RON
  11. R

    h 3 reverse

    does the lever have some snap when you go from neutral to reverse or forward ?? RON
  12. R

    cockshutt 20 deluxe laboring

    Do you have a 3pt. hitch,. could be on pressure.Just had one also got HOT!!!
  13. R

    torques farmall m

    need rod and main torques 1944
  14. R

    Re: 500c tracks help

    TRY POLAR PARTS IN SAVAGE MN.
  15. R

    Splitting a 3413

    remove hood,block up loader & remove brackets to rear axles. you have to back engine,trans.& rear end out of loader frame ,then remove engine to get to clutch. LOL RON
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top