-
RRonaldK replied to the thread 2030 electrical problem.Thanks. I do have a correction. I found a picture of the serial number plate and it was built in Dubuque. My 2940 was built in Germany...
-
RRonaldK replied to the thread 2030 electrical problem.We have two farms. One in Ohio and the other is 400 miles away in Virginia. We are in Ohio and won’t be at the other place for a few weeks.
-
RRonaldK replied to the thread 2030 electrical problem.Thanks. I am trying to find a single lead alternator to just bypass everything. It may not solve my problem but it may be a work around.
-
RRonaldK replied to the thread 2030 electrical problem.This is a Mannheim tractor. I should have mentioned it. The tractor is at our other farm. It will be several weeks before we go back. I...
-
RMy Deere 2030 stopped. It is definitely electrical. New starter didn’t work. I suspect it is the alternator. A “mechanic “ was...
-
RRonaldK replied to the thread Compression tester.Thanks. I don’t have that ability to modify the tester. Any suggestions?
-
RRonaldK replied to the thread Compression tester.Thanks. I will try that
-
RRonaldK replied to the thread Compression tester.I think a 65 diesel is a 3 cylinder. The 172 is a 4 cylinder. Not sure it’s the same injector ports. The 172 tester is much bigger than...
-
RRonaldK replied to the thread Compression tester.I have tried the generic testers. The one for the ford is larger. I actually bought a set that was supposed to fit all diesels and they...
-
RDoes anyone know where I can buy a compression tester for a Ford 172ci diesel engine. The last time I needed one, I had to borrow one...
-
RRonaldK replied to the thread International 886 air conditioning valve.Thanks for the suggestion. I got brave and after spraying some valve with pb blaster, I put a vise grip on the shaft and it loosened up.
-
RRonaldK replied to the thread International 886 air conditioning valve.Thanks. The port is covered and I am trying to turn the valve clockwise. Over the years, the valve stem end has rounded a bit and I...
-
RRonaldK posted the thread International 886 air conditioning valve in Farmall, International & McCormick.I need to recharge my air conditoning. I have the original set up with a new compressor. I know that I need to uncap a valve and turn...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy