(800) 853-2651
SHOP NOW

Recent content by Ross Bryner

Yesterday's Tractor Forums
  1. Z

    560d

    Hello, Can anyone help me get the housing for a 560d tach gear off? The metal gears are stripped. My slap hammer doesn"t budge it. See pics Thanks zeke5738
  2. K

    David Brown 780 Keeps Dying

    I have a DB 780 which stutters and dies. She may run for an hour or 5 minutes before this happens. It appears it is a result of lack of fuel. I have replaced the fuel pump, had the injector pump rebuilt, pulled and cleaned the fuel tank, replaced the fuel filters and it still happens. I am out...
  3. B

    Ford 4100 leaking oil at bellhousing and making gear noise

    Oil runs from drain on bellhousing and the oil level on rearend becomes low after a few hours use. Hydraulics become slow and there is a clunking noise from what sounds like the rearend. I'm guessing a bearing has failed and taken a seal with it. Any ideas????
  4. P

    update on 1755 hyd pump

    started on pump problem by r&r the pressure control valve, ball, springs , o-rings all fine , next i r&r the hyd pump bearings , and all internal parts looked fine , no nicks or gouges or groves from wear, r&r compensator valve all lookes fine , reinstaled all parts, instaled gauge according to...
  5. R

    Late Tractors with Belt Pulleys and Hand Cranks

    Sometimes my curiosity gets to me. . . and I have to ask questions in this tractor forum. While looking at my old 1951 M the other day; (cant wait till spring so I can run her a bit) I was noticing the belt pulley and hand crank (and both still work just fine !). MY QUESTIONS: What is the...
  6. R

    F-20, F-30 Road Gear

    Did the later F-20's and F-30's on rubber tires come equipped with a fifth gear similar to that on an H and M (with a max speed of 16 to 17 mph)? If not, what was the top speed of their high gear? Also did the F-12 and F-14 have high gear similar to the A or B ? Thanks, Ross.
  7. R

    Weight Difference Between 4010 4020

    Hey John Deere Experts ! ,. . .I noted something interesting while leisurely reading my C.H. Wendell book of Nebraska Tractor Tests. The 4010 was tested at 84 pto horse but only weighed 7000 lbs (without ballast). The 4020 3 years later was tested at 95 pto horse but weighed a beefy 8700 lbs...
  8. R

    THANKS . . . For Landscape Tractor Comments !

    GENTLEMEN . . . MANY, MANY THANKS !!! I am very greatful for the NUMEROUS replies to my questions I posted a couple days ago as to what to look for in Landscape Tractors. I have printed your responses and will use the suggestions as a basis in deciding which direction to go. I will study up...
  9. R

    What Is A Good Landscaper Tractor ?

    GENTLEMEN . . . MANY, MANY THANKS !!! I am very greatful for the NUMEROUS replies to my questions. I have printed these responses out and will use your suggestions as a basis in deciding which direction I will go. I will study up on each of these tractor models (thanks to great info. on this...
  10. R

    What Is A Good Landscaper Tractor ?

    I would like opinions out there as to what is the best 1980's to 90's tractor to be used as a landscaper tractor. (Has to be that old so I can afford it.) I will use it on my own small acreage and do a little landscape work on the side; maybe 3 or 4 times per year. I want it to be a utility...
  11. R

    580 Case Backhoe Drawbar / Hitch

    Thanks 135 Fan for the Reply. One thing I am wondering about the transmission in a 580; doesn't the 580 Landscaper / Loader which is basically a 580 with loader on front but with a three point hitch on the rear instead of a backhoe have the same transmission as a 580 Backhoe / Loader? These...
  12. R

    580 Case Backhoe Drawbar / Hitch

    Has anyone fabricated or know of a simple drawbar hitch that can be welded or bolted onto the back of a Case 580 loader / backhoe ? To me a logical place (perhaps the only place) that it could be mounted would be on the bottom of the backhoe boom just behind where the boom pivots on the large...
  13. R

    1494 Case (David Brown)

    Hello again Kow Farmer As far as specs, I know from a Tractor Data book the 1494 is rated at 75 pto horsepower. I think it was never tested at Nebraska, but the 1490 which was the same tractor, just the previous older model was actually tested at something like 72.8 pto horses. The engine is...
  14. R

    1494 Case (David Brown)

    Hi Kow Farmer Here are photos shot January 2009. I am in Price, Utah. As you can tell, it is a nice, straight, clean tractor (I just rather have an International Harvester !)
  15. R

    Sound Guard Cab On 630, 730

    Has anyone ever heard of; or seen a modern sound-guard cab modified and fitted on a 630 or 730 row-crop John Deere ? Obviously, provision would have to be made for the belt pulley wheel and the fly-wheel housing and the fact that the operator platform is so far forward. I have seen a photo of...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top