(800) 853-2651
SHOP NOW

Recent content by runningbird-HT

Yesterday's Tractor Forums
  1. R

    Stupid question

    you can use the lower one. use a 15/40 diesel oil, takes about 1 gallon, but check dip stick has you fill.
  2. R

    FX26D

    the fx28 does not have a turbo.
  3. R

    FEL for Yanmar 220D

    if you look on the belly of your tractor, as well as the frame along the sides you will see holes that have plastic or rubber plugs in them. take measurements of where those holes are and the distance to the front of the frame. You can then help coldwater or Koyker match up brackets that will...
  4. R

    How to load tires?

    I've heard of the Rim Gaurd. To much money for me. I just had my fronts foam filled and like it. My backs are filled with water, window wash fluid. and seem ok. if I could afford it I would foam fill the back as well. By the way there are a few other Yanmar owners in Chino.
  5. R

    F235 3pt not operating

    that is it, it is about 6" long, and you will loose your fluid when you pull it out.
  6. R

    F235 3pt not operating

    i think there is a screen on that model. I have one on a fx22. if you are sitting in the seat it should be on your rt hand side. when you find it, take out the three bolts holding it in place. gently tap with a hammer to break the seal. do not pry or you make break the cover. it could be...
  7. R

    F235 3pt not operating

    check the screen for the hyd. system.
  8. R

    YM2000 loader question

    if you just bought it, have the dealer check it out.
  9. R

    Bad Hydraulic Pump???

    only 56 hours on a 2610? i'd be asking the dealer to fix this for free.
  10. R

    My Yanmar

    looks great! tell us about your hydraulics.
  11. R

    Power shift

    Does the tractor move at all? I had a problem where it would happen intermittently. Then it just quit moving altogether. I replaces a spring in the valve that is under the center cover next to your rt heel if you are sitting in the seat. Very easy to get out, small snap ring then a 6mm bolt...
  12. R

    155D Not Starting -- Please Help

    are you going to rehone the cylinders while the pistons are out?
  13. R

    power shift problem

    OHHHHHH now I got it. in that valve was another tiny snap ring with a piston behind it, very little pressure, got the piston out and behind it was what was left of a spring, broke in about 8 pieces. hope hoye has the spring I need. thanks Guys!
  14. R

    power shift problem

    thanks for the help. I did pull that valve is the spring further in? again thanks for the help!
  15. R

    power shift problem

    ok got it....how hard is this spring to get to. is it in the releife valve? thanks Mark. I did email you with my email address.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top