(800) 853-2651
SHOP NOW

Recent content by RyanKve

Yesterday's Tractor Forums
  1. R

    450 Hydraulic Flow Control Valve

    Thank you. Ill try this too when I get my next chance.
  2. R

    450 Hydraulic Flow Control Valve

    Originally I took it out and sanded down some of the edges with 2000 grit sandpaper and some oil in case of burs, I guess. Made sense at the time. When I put it back together, the hydraulics worked consistently for a few weeks, then went back to intermittent. When I get to pulling it out again...
  3. R

    450 Hydraulic Flow Control Valve

    Good evening all. I have a Farmall 450 diesel that you all probably remember. For a while it has had the issue with intermittent hydraulics. I am lead to beleive that it is the flow control valve, springloaded on the side underneath the plug with a snap ring. I believe this because while...
  4. R

    Replacement Carb. John Deere 60 Lawn Tractor

    Good morning all, One of my friends asked me to take a look at his John Deere 60 Lawn Tractor. I am lead to believe that the throttle shaft has a vacuum leak (it changes in idle when shot in that area with brake cleaner). I have searched online and called the local John Deere dealer and cannot...
  5. R

    Farmall 450D hyd. loss of PS, remotes

    Ryan - owner of the 450D I apologize for my lack of knowledge but I'm hoping I can throw some ideas out there. The acting switch only turns about 1/8th of a turn with some side to side wiggle. I first twisted it, after the issue arose, I expected more than 1/8th of a turn unless that is...
  6. R

    Farmall 450D hyd. loss of PS, remotes

    Ryan - owner of the 450D I apologize for my lack of knowledge but I'm hoping I can throw some ideas out there. The acting switch only turns about 1/8th of a turn with some side to side wiggle. I first twisted it, after the issue arose, I expected more than 1/8th of a turn unless that is...
  7. R

    Weak / Tightening Farmall 450 Brakes

    Good morning all, I recently acquired a Farmall 450 and was able to get the whole tractor running beautifully. The previous owner supposedly put on all four new brake discs, as well as new boots and new bolts for the cover. The brakes on the tractor are strong but they won't lock up the...
  8. R

    Farmall 450 Torque Amplifier

    Hello all, Recently I purchased a Farmall 450 diesel. After slight repair I was able to get it running on gas and diesel excellently. The tractor makes gobs over power, however it is having issues with the clutch and T/A. In fifth gear it slips and wont move with the t/a forwards. However...
  9. R

    Farmall H Sleeve Protrusion Spec

    Thank you very much D Slater I bought a sleeve inserting / removing tool from something like "J&D productions Inc.". I ve been using that to tap on to push the sleeves down. I didn t know if it was something I should try spending my time to get it flush if it s either fine or perfect. I...
  10. R

    Farmall H Sleeve Protrusion Spec

    All of them are around 0.005". It has dry sleeves. I just can t for the love of my 1.5lb. hammer seem to get them any less than .005
  11. R

    Farmall H Sleeve Protrusion Spec

    Good evening everyone Does anyone know what the sleeve protrusion should be on a farmall H? My sleeves currently seem to be sitting at .005" above the block deck. I hear some people are saying .006" max and some say perfectly flat. I figured I would ask everyone here before possibly wasting...
  12. R

    Farmall Kerosene Oil Type

    Everyone says that 15-40 DIESEL oil is best for a farmall H. Does this apply for kerosene motors or does it need a special type. I remember reading something about using Rotella brand oil.
  13. R

    Farmall H Kero vs Gas head rocker arms

    I am able to get kerosene at a 7/11 pump for $4.20 / gal. This post was edited by RyanKve on 05/20/2022 at 03:36 am.
  14. R

    Farmall H Kero vs Gas head rocker arms

    No, I guess someone rebuilt the motor at some point and installed a replacement gas head. All of the kerosene / distillate parts were left on it though.
  15. R

    Farmall H Kero vs Gas head rocker arms

    Yes, I have all of the kerosene components. Functional kerosene vaporization manifold, heat shield, kerosene carburetor (drain), aux. tank.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top