-
S
Ford 600 12 volt conversion
Thanks for the drawing. I did replace the coil to one with an internal resistor. Going to start over tomorrow and see what happens.- Sailorjim01
- Post #3
- Forum: Restoration Processes
-
S
Ford 600 12 volt conversion
Purchased my 600 a few months back and it was wired 6 volt. I have done a 12 volt conversion and it has only ran one time since and then I had to jump it because I found my neutral safety switch bad. Ordered a new one and found a previous owner had welded the shifter and shaft together making...- Sailorjim01
- Thread
- Replies: 4
- Forum: Restoration Processes
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy