Recent content by SAM MARKS

  1. C

    Colby 560 progress July 11th

    more work tonight.... need few more little things, imagine that. rebuilt distributor, hyd hoses, dash work... few other things
  2. G

    Bought Bolens Iseki Tractor & 7 Attachments....Value?

    Hello, I bought a Bolens Iseki tractor that has been garage kept, it has the tractor tires w/lots of tread, it needed a battery and some new cables but fired right up and seems to run strong with no leaks anywhere. It came with 7 attachments: 2 brush hogs, a blade, a towing attachment, an...
  3. D

    Parts are on the way!!

    I ordered my pump, gaskets, friction disc, filters (hydraulic and rear end lube) and a few other things from agpartsfirst. I've ordered from him in the past and I've been very satisfied with what I've gotten. Now I just hope it can get to the farm sooner than later. Main problem I have is my...
  4. D

    Yesterdays project

    Dad got a small jack hammer and I busted up and repoured the corner wheel for the barncleaner that broke out (pulled the studs out of the concrete) about 1 1/2 years ago (dead of winter if you do the math). Dad had it fixed to where it had a bar over the top of it and if you parked a tractor...
  5. M

    Batteries blowing water through caps

    I have two 6V batteries that have been pushing acid out through the caps for the last 5 years. There's ALWAYS a puddle on top of each battery. People tell me this is because the batteries were overcharged. They have NEVER been overcharged. I have been extremely careful about that. I keep them...
  6. Ed S.

    Ignition Switch Failed...

    After putting up hay last weekend, I gave all the tractors a good pressure washing, and afterwards, the 8N wouldn't start. Figured it was water in the distributor cap, so I pulled it and wiped it out good. The tractor popped and ran on two cylinders for about 15 seconds and quit again...
  7. T

    Amp Gauge after 12 volt conversion

    What do i need to do to make my ampere gauge work after a 12 volt conversion? Is there a gauge common for people to switch to?
  8. F

    3000 power steering valve

    There is a little spring relief valve on the power steering box that is leaking. The spring seems pretty loose, so I'm guessing I need a new one. The parts diagrams says this part is no longer serviced. Is there some substitute or other option to fix this?
  9. H

    SoundGuy - Stuck Ford 3000 in FLA

    here
  10. S

    naa no oil pressure

    Did it have oil pressure after rebuilting ? if not might bewrong size mains and bearings like .020 .030 or so just a possible cause.
  11. S

    Which fuel tank sealer is the best?????

    I have fixed some with red from napa with rust and small holes, put inside tank dump it out than again coating inside let 24hrs never had any problems after that
  12. S

    Which fuel tank sealer is the best?????

    red from napa is good and will hold rust
  13. S

    OIL PAN FOR 340 UNT INTERNATIONAL

    I NEED A OIL -[PAN FOR A 340 UNT. FARMALL WITH A C135 ENGINE, SEND PRICE TO E- MAIL WITH INFORMATION NO JUNK I WANT A GOOD ONE OR WHERE I CAN GET ONE THANKS GARY
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top