(800) 853-2651
SHOP NOW

Recent content by sbaugh1964

Yesterday's Tractor Forums
  1. S

    Wiring diagram for starter

    I need a wiring diagram to connect this starter. Thanks, Stuart
  2. S

    Oliver 1250 - No Throttle to control rpm.

    Here are a few photos and a video. [video play=false:ea8f05e2a9]https://forums.yesterdaystractors.com/videos/mvvideo76117.mp4[/video:ea8f05e2a9] This post was edited by sbaugh1964 on 05/28/2021 at 09:06 pm.
  3. S

    Oliver 1250 - No Throttle to control rpm.

    Its gas.
  4. S

    Oliver 1250 - No Throttle to control rpm.

    I have moving the tractor from one field to another when the rpm went from 2000 to 1000 in a few seconds. I noticed a spring missing that connects a lever to the frame that is part of the accelerator. I replaced the spring but there seems to be a broken link with the throttle. I was wondering if...
  5. S

    2N tractor color

    So Ive used a wire bush to confirm this and Ive gone around the tractor with shock and confusion. The serial number on the engine appears to start with 9N293 and the casting of the frame behind the seat on the right side is 2N.below the stamp date (3-7-47). The color of most of the tractor...
  6. S

    Tractor Starter issue

    There's a starter (button) on the transmission that is connected to a starter switch. Above the starter switch, there is a cutout relay. Stuart
  7. S

    Tractor Starter issue

    The battery is fully charged at 6.4 volts and has 640 cold cranking amps (tested).I have voltage across the ignition, resistor, ammeter and to the coil and the pigtail.
  8. S

    Tractor Starter issue

    My 2N recently had a tune-up, new harness, new plugs, distributor and coil, ignition switch and resistor (less than 20 hours of use since tune-up). Everything was working fine without any issues but I went out to start it after a short break (3-4 hours) and it won't start. There is no clicking...
  9. S

    2N Tractor won't start

    Looked over every connection again and then went through the distributor again and then gave it another go. Started right up and sounds great! In the end it was the distributor points not making contact and I want to thank everyone for your advice and comments. I feel I got to know this tractor...
  10. S

    2N Tractor won't start

    Installed new points, rotor, and cap. Admusted points to 0.015. Tractor seemed to want to start (4 attempts) but didn't. The ammerter did register a few amps with the key turned to the on position. Had a few other things to attend to and removed key from the ignition and came back 10 minues...
  11. S

    2N Tractor won't start

    The tractor was running but sat for 3 months in the winter. I winterized it and started it just to keep it happy. However, now it won't start. I have clean connections between the ignition, ballast resistor, ammeter, cutout, solenoid, battery, generator, and distributor. The carburetor is in...
  12. S

    Single bottom plow hook up on 2N tractor

    I've watched the video and read the descriptions above which I can follow and apparently I'm doing things right but I'll get better hooking up the plow with time. Thanks Stuart
  13. S

    Single bottom plow hook up on 2N tractor

    Does anyone have specific step by step instructions for hooking up a single bottom plow to a 3 pt hitch on a N series tractor with the post hook up adjustments needed? Diagrams and photos would be great and a video would be better. Thanks, Stuart
  14. S

    Removing the lead wires from distributor cap on 2N tractor

    Thanks, Stuart
  15. S

    Removing the lead wires from distributor cap on 2N tractor

    In the service manual for 9N and 2N tractors it says to pull the spark plug lead wires away from to the distributor cap. Do they just pull away with a firm tug? Is there something I need to be aware of when removing the wires other than the order? Thanks. Stuart
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top