Recent content by scooter4

  1. S

    Case 1950 D crankshaft rear plug pin

    PostPosted: Sun Jul 12, 2020 5:14 pm Post subject: Re: Case DC oil pump spring Reply to specific post Reply with quote Edit/Delete this post Good evening, I finished my spring tests and have the following information for anyone who needs a Case DC spring. This produced 30 psi for my system...
  2. S

    Case DC torque specs

    I used 70 ftlb on the oil pump to block bolts, but as I got further in the project I found comparative bolts for the engine to transmission torqued to 50 ftlb and that is probably what they should have been. Too late, because it is already together.
  3. S

    Case DC oil pump spring

    Good evening, I finished my spring tests and have the following information for anyone who needs a Case DC spring. This produced 30 psi for my system. I just finished shimming main and rods to max .002". I also resurfaced and lapped my relief plunger and seat. The closes spring material I...
  4. S

    Stop welding ring gears on

    I should mention the process. 1. install ring gear as normal or fixing one already installed. 2. seal one side of flywheel/gear so the Loctite does not run out. Penetrating Loctite is used to wick between the gear and flywheel. 3. lay the flywheel flat with unsealed...
  5. S

    Stop welding ring gears on

    Good evening, 3 years ago I replaced the ring gear on my Ford 2N and measured that it was .010" bigger inside diameter than should be. When I did searches I found others had complained of them slipping and were welding them on. I felt like there was a better option. So it has been 3 years...
  6. S

    Correct and incorrect N series ring gear examples

    Good evening, So it has been 3 years since I installed the ring gear using green penetrating loctite instead of welding it like others do. The ring gear has not moved and I think welding the gear on is damaging and unnecessary. Follow my instructions on how I did it, except I did not use...
  7. S

    Case DC torque specs

    Good evening, does anyone know the oil pump to engine torques? Thank you, Scooter
  8. S

    Case DC oil pump spring

    Good afternoon, no harm in giving someone good advice not to mess something up. I have designed springs so that will help. The unkown for me is not having a NOS to copy, but I can get close if the spring stock has similar spring rate. The link you posted is the source of the spring stock...
  9. S

    Case DC oil pump spring

    Good morning, I can appreciate the concern, but we need springs and someone has figure it out a source besides handing a spring manufacturer a NOS spring and paying for a 1000 piece run. When I receive the spring stock I am going to make sure it has the same number of coils per inch, the...
  10. S

    Case DC oil pump spring

    Good evening, 410-398-7340 may have some but cant find them right now. Don only had a used one available and I am not wanting to do that unless no other option. I am worried about it breaking. So, I have ventured out and purchased spring stock that is the correct od and wire diameter, but I...
  11. S

    Case DC torque specs

    Thank you for adding the bearing information. Scooter
  12. S

    Case DC oil pump spring

    Thank you for the replies. Scooter
  13. S

    Case 1950 D crankshaft rear plug pin

    Good morning, can anyone tell me where I can buy a Case DC oil pump spring? I have looked around, but not found one. Mines is broken up. I could also make for find one if someone can tell me the specifications. I am going to adjust the main and rod bearings while I am in there, I am lucky...
  14. S

    Case DC torque specs

    Good morning, I put the rod bearing clearances, but do not know the mains if anyone has that. Thank you, Scooter
  15. S

    Case DC oil pump spring

    Good morning, can anyone tell me where I can buy a Case DC oil pump spring? I have looked around, but not found one. Mines is broken up. I could also make for find one if someone can tell me the specifications. Please let me know. Thank you, Scooter
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top