Recent content by Scot Webb

  1. M

    pto slipping on a jd 2955

    I have heard that you can shim the valve for your pto if adjusting the shift linkage doesnt help. Has anyone ever heard of this? if so how is it done? Thanks.
  2. S

    Ford 640 rough running when hot

    Thanks for the info...I'll have to look how close the line is running to the exhaust. It was about 95-98 degrees when I was mowing.
  3. S

    Ford 640 rough running when hot

    Not like that. It would not start a few months ago and I wanted to make sure it was getting fuel because the spark was fine.
  4. S

    Ford 640 rough running when hot

    Thanks for the replies so far. It is a 6v system. I checked fuel flow a few months back for another issue and it was fine then but will check again.
  5. S

    Ford 640 rough running when hot

    I have a 1957 Ford 640 tractor that starts instantly and runs well until it gets hot. It then loses power then recovers over and over again. Like it is surging. I am pulling a finish mower mowing about 2 acres and had to stop 3 times and run cool water over the radiator and then it runs just...
  6. S

    Pertronix Ignitor in a Ford 640

    Just bought and tried to install a Pertronix Ignitor electronic ignition conversion kit. Installed it and now tractor will not fire. Anyone know of a way to test the Ignitor module. Should there be resistance between the two wires then short when the magnet comes close? At a loss here and no...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top