(800) 853-2651
SHOP NOW

Recent content by scott1953

Yesterday's Tractor Forums
  1. 8

    John Deere 435 Power Steering Pump

    In need of a power steering pump for a 435D tractor. The one that is on it is a pump built by Webster Electric Pump, Racine Wisconsin, USA, is a model 2HC59-R. I don't think this is the correct pump and can't verify via the parts book. Any help would be appreciated. Thanks Ellis
  2. S

    super a blown hydraulic gasket

    Thanks for the replies. All is in working order now. Scott
  3. S

    super a blown hydraulic gasket

    You are right! Exactly. I had the gasket end for end. Big hole where the little hole should have been...I didn't see the hole size difference... Thank you for the quick reply. One more question, I have some fiber type gasket material Felpro Karropak it says on the back. If I cut...
  4. S

    super a blown hydraulic gasket

    I recently rebuild the hydraulic pump on my Super A (with the help of this forum). Problem was the pump shaft was worn allowing hydraulic fluid (ISO 32) to leak into the engine oil. I did check to make sure the pressure release ball and spring looked ok...they seemed to be fine. After...
  5. S

    super a hydraulic pump rebuild

    Thanks for the reply Jim I took it apart again and just spent more time looking at how it goes together and what parts fit where to allow it to turn freely. Then I realized my mistake. I misread the instructions, mixing up the bearings. Now it's back together turning easily by hand...
  6. S

    super a hydraulic pump rebuild

    I'm in the process of rebuilding the hydraulic pump on our super a. I was able to ID the pump as pesco, got the rebuild kit from Steiner. Got the speedi-sleeve on the shaft since it had a wear groove on it, that I'm thinking was causing the hydraulic fluid to leak into the crankcase. I plan...
  7. S

    super a still leaking coolent into the oil

    I took that break you all suggested. Now I'm back. It took the rocker arm shaft to my buddy at the local garage. He had to heat it up a good bit to finally free up the stuck tappet adjusting screw. It was pretty frozen, threads were ok. Put it back on the tractor, checked the head...
  8. S

    super a still leaking coolent into the oil

    Yes, I checked with one of those point and shoot thermometers. The inlet on the radiator only gets to 145 or so....I'll try the newspaper idea when I'm plowing snow....to cook off some of the condensation that develops Thanks Pete
  9. S

    super a still leaking coolent into the oil

    I thing your right....like a Swiss watch...yeah, I was a bit discouraged and really did not realize what a resource this forum is. :)
  10. S

    super a still leaking coolent into the oil

    Hi WellWorn...no clearance at all. I can't even get a .oo3 feeler gauge in there. And that adjusting screw it immobile. The local garage I use said he'd help me get it unstuck. So I'll take it down to him monday. He teaches me a lot like you all do. Maybe with the new rings, new...
  11. S

    super a still leaking coolent into the oil

    I suspect I (I really mean we) found the problem. I hope. I did the leak down test in all cylinders..careful to be at TDC on each. About 20 to 30% leak on all, all through the crankcase breather tube. There was no bubbling in the radiator for any cylinder. Air pressure was about 100...
  12. S

    super a still leaking coolent into the oil

    Here is how I've decided there is a leak...I so could be wrong about this but.. Both before and after the work I've done. I start with fresh oil...run it for 20 minutes or so, put a few drops of oil on the hot maniford and it just smokes....oil from my car behavies the same way on a hot...
  13. S

    super a still leaking coolent into the oil

    Interesting, but when I sent the oil to Blackstone labs, they tell me it is heavily contaminated. Lots of lead in the oil indication of bearing wear they tell me. But your right, It doesn't get very hot. Again thank you all for your advises and support and understanding of my limited...
  14. S

    super a still leaking coolent into the oil

    Not sure if this helps anything, but here is a pic of the block. Should I have sprayed some kind of crack indicator in there to find a crack? http://forums.yesterdaystractors.com/photos/45990_sml.jpg
  15. S

    super a still leaking coolent into the oil

    So your thinking head problem. Would it make sense to bring the head back a shop to be magna fluxed....another reply seemed to lean in that direction I really don't want to give up on this thing..esp based on what you all are saying I'm definitely too far from you...but thanks for even...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top