Recent content by Shawn O

  1. J

    #60 vs #70 IH Plow

    Could anyone please tell me the difference between an IH #60 and an IH #70 plow? Is there any different with the clearance? Thanks Joel
  2. S

    Mf 203 steering

    I have an old mf 203 workbull tractor. When I first got tractor it had a broke steering jack.I replaced it and then fluid was coming out of steering column so I replaced the seal and that fixed that but tractor was still very hard to steer. Took pump apart to find out it was shot so I got new...
  3. S

    Mf 203 steering

    Does the seal got to be driven down from the top of the steering column or can it be managed in from the bottom . Just got the seal today and am planning on installing in the next day or two . I am assuming it would go in from the top down but I've been wrong before , do you remember
  4. S

    Mf 203 steering

    Did your 203 steer easily with your seal leaking mine is very hard,thinking my pump might be on its way out but looks like a newer pump
  5. S

    Mf 203 steering

    Do you have to pull instrument panel to do the seal replacement or are theare enough room to do it with it on.also which part of the steering column is the seal located , like is it in the tube that comes up through instrument panel or in the steering box itself. Thanks
  6. S

    Mf 203 steering

    Just acquired massey ferguson 203 industrial with loader on front. Bought it running but not driving had to replace axle planetary,and one steering cyl. because of it being broke. Now when I try to turn tractor fluid comes out at top of column right under steering wheel. Tractor still is very...
  7. S

    12 volt conversion kit sold for 2n

    The alternator came with a tractor I bought it came with a kit with 12v coil and everything it is definitely not a delco
  8. S

    12 volt conversion kit sold for 2n

    Just got a 12 volt conversion kit and it has 3 terminals on alt which being b plus ,w,and d plus I know b goes back to battery but not sure of other two. With only b hooked up pulled pos cable off to see if alternator was charging and tractor began sputtering and backfiring any idea were other 2...
  9. S

    Problem with timing

    Firing order is right will take distributor back off this weekend And check everything again. Just wanted to know if I was on the right track with the problem coming from timing. Thanks A lot.
  10. S

    Problem with timing

    Just got done rebuilding 48 with front mount,rebuilding meaning new pistons ,sleeves, and bearings. Tractor ran good with plenty of power before and now idles fine but does not have a lot of power when under load like going up hill in 4th gear will stall out. Tractor also pops through carb...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top