(800) 853-2651
SHOP NOW

Recent content by ShermanPowerDigger

Yesterday's Tractor Forums
  1. S

    Identification help needed MM Model AID?

    Got my manuals today! Thanks, YT
  2. S

    Identification help needed MM Model AID?

    Yes
  3. S

    Identification help needed MM Model AID?

    Thanks to all for the help, based on the comments and a check of serial number against model numbers on tractor data site it is a model 335 from 1957. I will dig in a little deeper. See if I can get her running.
  4. S

    Identification help needed MM Model AID?

    The ID tag on this industrial tractor shows it as a model AID but that is not a model number for and m&m tractor. It may have had a backhoe at one time but it does have a loader. I will need to get some manuals on it but first got to identify it. Any help appreciated.
  5. S

    Guidance on Wire Sizes and other Rewiring Tips

    I wanted to thank everyone who gave advice, I have rewired my IH 404 and only have to complete wiring to the rear light. Since those wires were protected by thick insulation they may still be useable but someone cut them off close to the fender. If I can't pull them out a little more I will run...
  6. S

    Help identifying cub points and distributor

    I ordered an new condenser and points from YT for my cub but they don't fit. I did install the condenser but need help figuring out the points. I have fire to the points and a strong spark from the coil but nothing past that. All the pics in my manual show a horizontal distributor but...
  7. S

    Steering wheel puller

    I have a new steering wheel for my international 404 but the old wheel does not want to come off easily. There are two holes for a puller but before spending my cash is there a special puller needed? How do other folks get the old ones off. I'll likely replace the wheel on a couple of...
  8. S

    Thanksgiving

    Thanks and a Happy Thanksgiving to you as well!
  9. S

    Guidance on Wire Sizes and other Rewiring Tips

    Other than matching existing wires what more should be considered when rewiring an old tractor. My IH 404 needs it all. Should I worry about the connector plugs? Maybe add a bus bar instead? It does not have a resistor at the coil though one is shown in diagrams and one is on my other 404...
  10. S

    IH 404 stopped running

    Thanks for this tip. With the jumper wire I got it running and back to the tractor shed. I worked the problem back from the coil and found where the wires behind the key switch were burned up, power gets to the key switch but not past the switch so the wires may be burned up further into the...
  11. S

    IH 404 stopped running

    I did search the site for a wiring diagram but got nowhere. My old 404 has been a workhorse and doing some hogging when it just died. I was in some heavy briars and some wire must have pulled loose. The tractor has some wiring issues as the previous owner did some work on it. Some bad...
  12. S

    IH 404 Carburetor Problem?

    Thanks, I hadn't thought about the governor, I'll do some research on that.
  13. S

    IH 404 Carburetor Problem?

    Well it turns out YouTube is your friend. Many videos about rebuilding carbs. Gives the basic background info so at least a starting point for me. If I have to I'll order a rebuild kit before taking this one apart. Then I can retrace the steps and have spare parts if needed.
  14. S

    IH 404 Carburetor Problem?

    Ok, I am lost on this one. I ain't got gasoline running through my veins so please bear with me. My 404 just doesn't want to start. I took off the carb and had a tractor dealer's shop rebuild it. Also I replaced spark plugs, wires, points & condenser, dust shield, rotor, cap. It...
  15. S

    Farmall A Grill tools

    I'd like to know more about the tools mentioned, i did not know there was a special set of tools for this. Sheet metal is mostly good on my menagerie of old tractors but some work is needed. I'd like to se pics of the homemade tools as that's the route I would likely take. I'm guessing...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top