(800) 853-2651
SHOP NOW

Recent content by Steinkamp sales

Yesterday's Tractor Forums
  1. S

    Farmall m live hy

    The 1" port was already tapped in the lower front end of the belly pump when I got it . To make a long story short, I bought this m, knowing it had a bad clutch. Since I already had a like new clutch from super m parts tractor, I thought I would use that. After swapping flywheels so clutch would...
  2. S

    Farmall m live hy

    Hey all! So I have been working on changing farmall m to live hydraulics. I had Super m parts tractor which I took engine mounted pump off of, and got front timing cover and plate from salvage yard. I decided to purchase battery box under the seat and move battery back since I had seat from...
  3. S

    New. Holland LX 865. Oil consumption

    I agree with checking your crankcase vent. One other thing crossed my mind though. Several years ago I recall a 186 ih hydro that had the same problem as yours. If I remember correctly, one of the rocker arms was either broken or push rod was out of place or something. On intake stroke, the...
  4. S

    Sputtering 2510 gas

    I would lean towards an in ignition problem, perhaps points, plugs,cap and rotor. Also make sure your gas is without water and you have good fuel flow to the carb. Good luck!
  5. S

    Running lean after engine work/carb cleaning

    Are you sure you have firing order correct? I have run into that problem myself where it will idle ok, but cannot handle any advance of the throttle.
  6. S

    Reassembling the 560

    Great looking tractor. Job well done!
  7. S

    Case IH 2294 Tractor

    Pretty hard to turn around on the end with diff lock engaged don't you think?
  8. S

    Farmall M high idle

    It sounds as though you are sure you have the tang in the right place. Is it possible to install carb with either the governor tube pushed to the side, or else unhook it inside the governor? What I am saying is try to run throttle at carb manually by hand. That's the only way to know for sure if...
  9. S

    Avery A

    I sure wouldn't turn down the opportunity to own it.I am from Iowa ,and my wife and I bought an avery model a with a planter and cultivator about a year ago. It doesn't run but it is loose. Hoping to start on it this winter. Most general parts are available like wheels,guages,etc. Some things...
  10. S

    Starter or Batteries

    Replace batteries, problem solved
  11. S

    Heater doesnt work

    Only way to know for sure is to take a temp gun and check temperature at different spots. That way you can tell if thermostat is working.
  12. S

    Electronic ignition parts?

    I once had a similar problem myself.it was a pertronix and I called them directly at the company. They were great about it and sent me the part I needed free of charge. It doesn't hurt to ask. Good luck!
  13. S

    Ford 641 Overcharging

    Is your battery currently discharged? Perhaps leave battery on for a few hours, and try running tractor again. I would bet your problem goes away. How is the condition of your battery? If in doubt, have it tested. Good luck!
  14. S

    Farmall M timing

    Pull valve cover off top of engine. Turn engine until number 4 cylinder is on valve overlap. This means as you turn engine, number 4 exhaust valve will be closing the same time number 4 intake is opening. That tells you that number one cylinder is on top dead center compression stroke. Time your...
  15. S

    Farmall m

    I had the same problem. Overhauled an m with a bad head. Replaced head with a brand new high compression head since that was all that was available. Used it to grind feed to break in engine. I thought it sounded that way also. This tractor also had domed pistons. I did verify that the piston...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top