(800) 853-2651
SHOP NOW

Recent content by Steve (PA)

Yesterday's Tractor Forums
  1. S

    Zang Thang

    A little off subject, but doesn"t the Zang Thang cause the hydraulic system to be constantly adjusting? And doesn"t this cause excessive wear to the old pump systems?
  2. S

    Ferguson plow

    Two bottom. $325 http://altoona.craigslist.org/grd/3582614090.html
  3. S

    Another TO-20 on Craigslist $2000

    http://harrisburg.craigslist.org/grd/3638938953.html
  4. S

    TO-20 on Craigslist $1800

    http://harrisburg.craigslist.org/grd/3573984331.html
  5. J

    Snow that Farmall Cub plowed

    This pic shows some of the snow the this 1956 Farmall cub plowed, This plow works great when the snow is fresh and not heavy or wet. From: JR Frye
  6. R

    Coolant Capacity of Farmall H

    Anyone know right off hand the coolant capacity of a farmall H??? Thanks Ryan in Northern Michigan
  7. S

    quadrant 'stop' bolt

    I reread the article and you're correct. It was talking about 'position control'. Next time I'll focus on the material so as not to be a dummy.
  8. S

    quadrant 'stop' bolt

    The August issue of the Furrows has an article on restoration. It notes in the article that there should be an upper 'stop' bolt in the quadrant slot. My TO 30 doesn't have the upper one. Is it necessary?
  9. S

    TO-30 Exhaust manifold

    I recently installed the same manifold on my 30 and found that I needed to grind some of the areas on the manifold around the stud nuts in order to gain access with a socket or end wrench. Check that before you start to torque it down.
  10. S

    water pump

    Thanks for the informative reply. As soon as the barn warms up, I'll pull the old pump. Think I'll have the radiator flushed and pressure-tested while I'm working on that end of the engine.
  11. S

    water pump

    On my TO 30, does the water pump have a 'weep hole' that allows coolant to dribble out when the seal or bushing is wearing out?
  12. S

    Top Water neck for TO-20

    When I bought my TO30 it already had a plug brazed in the temperature sensor hole. I bought a used water neck on eBay and installed a temperature gauge. I'll send my old one to you if we think it will fit, but since overheating these old engines tends to crack the block, I'd recommend buying...
  13. S

    what a site!

    I've done that twice now and before you do any wrench bending, hook your truck to it and pull it backwards a couple of inches. That should take the 'load' off the gears. Good luck.
  14. S

    TO 30 Hand Crank

    Thanks Jeff, Got it. I knew it had to be simple. I always have trouble with simple.
  15. S

    TO 30 Hand Crank

    OK. I give up. I've looked through the 'parts list' three times and can't find the hand crank. There doesn't appear to be a 'search' program available. How did you find it?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top