Recent content by Stritecase

  1. S

    Case2290 hydraulic issues

    I did manage to get a case manual from a buddy so sometime when I get time I can dig deeper. after the filter change it actually performs pretty good , the filter light doesn’t come on anymore but sometimes the trans oil light comes on?? , I used it to Ted some hay & pull a bale cart so nothing...
  2. S

    Case2290 hydraulic issues

    I’m only getting 50psi at Full throttle
  3. S

    Case2290 hydraulic issues

    Yes , the flow valves are wide open.
  4. S

    Case2290 hydraulic issues

    Update: I got new filters installed & I do believe it helped the situation. The jumpy gauge has pretty much stopped, but There are two anomalies I now see, with the oil warmed up & running at 1800rpm , holding the pressure at 1500psi, it will be flowing about 10gpm, then when you raise the 3pt...
  5. S

    Case2290 hydraulic issues

    Before we bought the tractor it had been fully serviced including hydraulic filters, at the start of these issues I pulled them out to look at them & also I pulled the suction screen out & cleaned it up, that helped with the hydraulic noises you refer to, I feel like it’s not really noisy now...
  6. S

    Case2290 hydraulic issues

    So with a flowmeter hooked into an outlet & dumping into the hydraulic oil filler hole it was running like 10gpm @1500, I didn’t observe any difference between powershift gears other then during the shift. The thing is the gauge was just really jumpy at times, like fluctuating the needle from...
  7. S

    Case2290 hydraulic issues

    Ok I can do that again, actually did that the first time I was dealing with the issue & found the broken spring, during that test I didn’t see any differences between the gears. What would be involved with the compensator? Is that something you can rebuild or they get replaced?
  8. S

    Case2290 hydraulic issues

    Recently bought a 2290 that is now giving us hydraulic issues, it randomly will loose hydraulic outlet function & 3pt function. Has never had an issue with steering, brakes or PS . With a flowmeter hooked up it right now it doesn’t have much flow then goes to 0 when pressure is applied. I had...
  9. S

    Case 970, power shift or standard?

    Actually, allow me to correct myself . that is a power shift tractor.
  10. S

    Case 970, power shift or standard?

    That tractor is an 8spd transmission, not the power shift. 8spd is Good transmission for pulling, will hold allot of HP without much upgrading.
  11. S

    1030 Upper Draft Arm Location on rockshaft

    Still have a weak outlet, ran out of time to figure it out.
  12. S

    1030 Upper Draft Arm Location on rockshaft

    We had our 930 apart over the winter & I don’t remember there being anything like that, they could go on anyway.
  13. S

    930CK & 1070 same Hyd. Problem. I'm stumped

    I just got a chance to use a flow meter on the 1070 & I have flow & pressure on the one side,(lever pulled back) but on the other side I only have 8gpm with no load, put a load on it & the flow goes to nothing.
  14. S

    930CK & 1070 same Hyd. Problem. I'm stumped

    On the 1070, there seems to be no pressure from the top right side remote. I can’t use that outlet for any hose requiring pressure.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top