Recent content by Super Powers

  1. S

    570 Super rocker shaft oil leak

    Thanks Phil, knowing that oil shouldn't come out at the end is all I needed to take out the shaft and find out why it does. I'll be back in touch soon to get a couple more things to finish this project up. until that time.
  2. S

    570 Super rocker shaft oil leak

    To condense my above post and question- I'm not sure if oil is supposed to gush out from the front end of the rocker shaft.It appears that oil is supposed to be supplied from both ends to create enough pressure to squirt out the rocker arm oil holes. I'll remove the shaft and find the problem if...
  3. S

    570 Super rocker shaft oil leak

    First I want to thank all that helped me with an earlier injection pump leak on my 570.I did manage to reseal it and it seems to have stopped the fuel from diluting the engine oil. Now I'm onto adjusting the valves on it's Hercules 339 diesel and after I was done,I fired it up to make sure the...
  4. S

    570 Super PSB injection pump leaking

    Hello Mr. Heisey, thanks for your reply.I've gotten parts for my Cockshutts from you in the past and plan to give you a call again soon for more. I looked in my email and couldn't find a message from you.My address may not be the same now as the one you have. It's now [email protected]
  5. S

    570 Super PSB injection pump leaking

    I am back to work on my Cockshutt 570 Super pulling tractor and need help fixing a leaky PSB6A pump. The Ole Girl has been sitting in my garage for 5 years after confirming fuel was leaking into the engine oil.At that time it had a oil pan gasket leak and I thought the oil had a faint fuel smell...
  6. S

    570 Super fuel in oil

    Thanks for the reply's, guys.I'll start by checking the transfer pump seal and hope to find the problem there, if all goes well next week.
  7. S

    570 Super fuel in oil

    My Super is leaking diesel fuel past the PSB pump and into the engine oil. I know this subject has been discussed in detail many times and the most likely culprit is one or more of the pump seals. I changed the oil last spring and wouldn't run it again until I could fix the fuel issue and a...
  8. S

    Turbos

    I got info and a turbo kit for my diesel 570 from Keystone and am real happy with the results.Since there wasn't a specific kit for my tractor I had to design and make all the air in and exhaust out plumbing but it was a fun job and well worth it. A friend of mine got a complete kit specific for...
  9. S

    Turbo 570 Super fuel in oil

    Another fuel in oil question but first I'll give a little background and update on my tractor. I posted here a few times last year about adding more power and thinking about going with a turbo.I was very successful in adding a turbo to the otherwise stock 570 Super diesel pulling tractor last...
  10. S

    New England Championships

    Showcrop,All the info listed above is correct according to a info sheet given to me except I believe you ment Haverhill MA. instead of N.H. I wish it were NH since I'm only 45 minutes from that pulling track. The address is 140 Willow Ave Haverhill,MA 01835. Scales open at 7:30 AM
  11. S

    570 PTO removel

    Coopkid: Thanks for the info.I looked at my 40 parts tractor and realized it is different then my Super.The 40 has a support bearing on the rear end of the power shaft held in by two bolts and retaining clips so leaving it in wouldn't be a problem. My 570 Super's power shaft depends on the PTO's...
  12. S

    570 PTO removel

    Hello OC I think I'll keep the PTO intact as it comes in handy if I make changes and want to dyno.The plates are a little weak and won't give me the full HP reading before they start to slip at 100 HP.Still good enough to check my turbo boost pressure though. Phil has the clutch plates still I'm...
  13. S

    570 PTO removel

    Hi Phil,I would have called you if I'd realized any such part was made.I'd love to have it and I'll call you tonight.Thanks
  14. S

    570 PTO removel

    I only use my 570 Super for pulling so I've removed the entire PTO in order to get into a lower weight class.A PTO is not required in the division I'll be pulling in so I'll make a plate to bolt to the rear in it's place. Do I need to also remove the power shaft coming back from the trans with...
  15. S

    570 Super Turbo install

    The Keystone Turbo kit for my 339 Hercules diesel will arrive soon and I'll be installing it on my pulling tractor this week.I'm not a career mechanic but have spent my life around and working on all kinds of engines and machinery and always trying to learn more.I understand the basics of...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top