-
T
Ford Jubilee has a hydraulic leak.
I bought the cover on ebay and it fit and works great. Thanks for your help. -
T
Ford Jubilee has a hydraulic leak.
I bought this cover and should know in a few weeks how it worked out. I have a large garden and will be working there for a while. Thanks for your advise. -
T
Ford Jubilee has a hydraulic leak.
My cover does have a metal spacer plate but is a single piece and has 2 oblong openings where seals go. Could the cover plate on ebay fit and work on my tractor? -
T
Ford Jubilee has a hydraulic leak.
Maybe they packaged it wrong. There is only 1 offered for the 1953 jubilee. Everything else in the kit are right. -
T
Ford Jubilee has a hydraulic leak.
That works for the larger one but the rings are too big for the smaller one. -
T
Ford Jubilee has a hydraulic leak.
I just bought this and tried to get the o -rings under the top plate. The original are oblong shaped. The ones in the top kit I ordered are round. Every site I look at only show round ones. Does any one know what I can do. -
T
ford 860 not staying in 3rd gear
Thanks for the pictures. My third gear looked about the same so I ordered a new gear from this site. I have pulled the transmission out and took everything apart. It wasn't hard but took a lot of time. Thanks for every ones help. -
T
ford 860 not staying in 3rd gear
It finally warmed up a little here in NY and I pulled the top cover off the transmission and put the shifter back on. Everything looks good. What should I look for? The gears look fine. Someone also said there could be too much play somewhere. -
T
hydraulic coupler on steering box
I don't know how to do the picture thing. Thanks -
T
hydraulic coupler on steering box
Thanks for the reply. That is what I thought as well. -
T
hydraulic coupler on steering box
No it doesn't. It is the typical hydraulic fitting used on most tractors I have seen. -
T
hydraulic coupler on steering box
The ford 860 I just purchased has a male hydraulic coupler on top of the steering box. This tractor does not have power steering. Why is this fitting there? -
T
ford 860 not staying in 3rd gear
I pulled the detente spring and seat out and they looked fine but I still pulled another one out and switched them around trying to see if that would help but no luck. I also looked at the shift lever where the seat contacts the lever and it looks fine so I guess I will have to go into the... -
T
ford 860 not staying in 3rd gear
Joel thanks for the advice. I will get a book to help me. I have repaired several manual truck and car transmissions over the years but never did internal work on a tractor transmission.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy