(800) 853-2651
SHOP NOW

Recent content by taroberts

Yesterday's Tractor Forums
  1. Farmall 130 just back together

    Farmall 130 just back together

    Farmall 130 just put back together
  2. IMG_0678.jpeg

    IMG_0678.jpeg

    Farmall 130 just put back together
    • taroberts
    • Media item
    • Comments: 0
    • Album: Farmall 130 just back together
  3. IMG_0679.jpeg

    IMG_0679.jpeg

    Farmall 130 just put back together
    • taroberts
    • Media item
    • Comments: 0
    • Album: Farmall 130 just back together
  4. IMG_0676.jpeg

    IMG_0676.jpeg

    Farmall 130 just put back together
    • taroberts
    • Media item
    • Comments: 0
    • Album: Farmall 130 just back together
  5. T

    Starting issue

    This is where we’re at now starting and running pretty well, battery box is about all I have left besides Farmall hood emblems and decals thanks for the input
  6. T

    Starting issue

    Mechanical advance seemed free also
  7. T

    Starting issue

    Not a magneto ignition, I could only get it to fire and run for a minute or so, so went back at through fuel system and it checked out good, so went back through ignition system plug gap, point gap, firing order seemed right, turned the engine around to compression on number one with piston at...
  8. T

    Starting issue

    Just FYI, went back through everything on this 130 related to fuel, ignition, and all it was was it was about 10/15 degrees out timing wise, made small adjustments until it cracks right off, was overthinking it go figure
  9. T

    Starting issue

    New fuel line also, new intake, so can the governor cause something like this, I’m wandering about that
  10. T

    Starting issue

    It’s has new sediment bowl on it and don’t see any debris to speak of, and gas dripping out of carb so I’ve got flow to there anyway 🤔
  11. T

    Starting issue

    6 volt
  12. T

    Starting issue

    I have a 130 that am rebuilding got it painted, rebuilt hydraulics, new wiring harness, new carb, new points wires cap and plugs, new spring in governor, when I try to start it it fires but won’t go ahead and pick up and idle, run for maybe a minute and die, was doing this when I shut it down to...
  13. T

    Farmall130

    Appreciate it, think we’re good to go on this.
  14. T

    Farmall130

    Got this compression tester and kit at Oriellys , got this thing pretty well stripped down so think I’ll put a coat of paint on it and put back together Thnx all for the input
  15. T

    Farmall130

    Quit ratcheting up I meant
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top