Recent content by tater417

  1. T

    MF 65 lift arms not going up all the way

    Will do, thanks to all for the feedback. I was messing around with it more yesterday and took some measurements with my spear on and at a nice level position. I lowered it all the way and it measured ~ 10" off the ground, then raised it all the way and it went to just under 20". I played...
  2. T

    MF 65 lift arms not going up all the way

    I've had it for several years and it has always only gone this high. Maybe it's gotten slightly less over the years, but hard to quantify how much less. For sure it should be going higher though. See in the pic how the lift arms in the picture go almost straight up. Mine only go about 90 degrees.
  3. T

    MF 65 lift arms not going up all the way

    I have a Massey 65 that I use mainly for moving round bales. The issue I am having is that the lift arms don’t lift very high. They may lift the bales only 1 foot or less. This causes issues when moving some larger bales cause they’ll end up dragging. The travel is the same with no load on the...
  4. T

    IH 504D Rebuild

    I have an IH 504D that I am thinking about rebuilding. Over the last couple years it has lost lots of power and started smoking a lot. Now it will start, but that's about it. I'm afraid to even move it from the barn for fear of not being able to drive it back in. I'm just wondering how...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top