(800) 853-2651
SHOP NOW

Recent content by Tbone550

Yesterday's Tractor Forums
  1. JoeM(GA)

    Massey 135 injecton pump removal

    I need any pointers or tips on removing the injection pump on my late Dads MF-135. I am told that I just need to remove the injector lines at the pump, loosen them at the injectors. Then remove the 6 bolts holding on the cover that has the oil fill, then there are three bolts to disconnect the...
  2. N

    Wider tires

    I just installed a front loader on my Ford 3000 tractor. It has 5.50x16 tires (practically new) but I'm worried they may not be enough to work with that loader. Do any of you know if I can upgrade the tires to 6.50x16 or something wider? 6 ply? Thanks...
  3. super99

    What is this?

    On a tractor ride in Yorktown, Illinois today. South of town is Amish country. There were a couple of small fields of this. One of the locals said that they used it for medicinal purposes but couldnt remember the name of it. It looked like a cross between weeds and trees, most of the small...
  4. S

    JD 720 gas starting problems

    Hi all, I am trying to get a few things rolling again on my tractors. The first problem Ive run into is getting my 720 gas to even crank. Here is what Ive done so far: 1/new battery 2/new starter switch 3/new ignition dial switch and cleaned wires 4/new battery cables 2/0 for positive...
  5. jon f mn

    Today's funny

    .
  6. B

    D-10 SERIES III

    Is there any interest in the D-10 Series III out there, what are the price ranges on these tractors now? I have 2 that I'll be listing soon, 1 has brand new Firestone rears brand new tires on front, metal is pretty good fenders are rusty on bottom and needs a seat, but will make a nice tractor...
  7. kcm.MN

    2019.10.24 Rust Pic

  8. B

    Farmall M Loader Wont Lift (Pics Video Inside)

    This message is a reply to an archived post by Faster346 on April 11, 2011 at 20:51:13. The original subject was "Farmall M Loader Wont Lift Pics Video Inside". glad I found this I've been pouring over pictures to figure out what loader I have (the labeling is barely visible and can't be read)...
  9. S

    8N Distributor Dimensions

    I bought a replacement distributor cap (P/N: NCA12106A) for my 8n, but it doesn t fit because the mounting surface of the cap is larger than that of the distributor. The distributor must have been changed at some point to an aftermarket one. The image I have attached shows that the timing gear...
  10. L

    235 Massey Ferguson

    I have a Massey 235 with a Perkins 3 cyl. There is a low pressure fuel line coming ffrI'm the top of the fuel tank to the fuel pump. The ferrel has broken that connect to the pump and is leaking awful. I have checked everywhere for a replacement amd no one seems to know what it is or where to...
  11. K

    Anyone use Hy gard in a 2cyl trans?

    So my 530 is leaking gear oil into the pto. I know I'll have to fix it eventually, however, it probably won't be until fall. I was recently reading a post on here where several members stated they used Hy gard in their pto with no issues. That got me thinking, could I just fill up the...
  12. B

    fordson super major power steering

    I have a 1961 super major with original power steering. Does anyone have an idea where to get parts for the cylinder who made it. I would like to rebuild it but parts seem to be no where to be found.
  13. S

    Governor compensating spring mf50

    I have a broken governor compensating spring on my MF50 gas. I know that one end goes to the throttle linkage arm but where does the other end hook? Can someone describe to me or possibly show a picture of one hooked up? Thanks in advance for taking the time to look. Steven
  14. J

    6300 tractor syncro plus transmission ?

    I m going to go look at a 6300 tractor with the syncro plus transmission. I was wondering if those are a good transmission and are there any common issues with these tractors or these transmissions ?
  15. B

    3000 replacing C7NNH856C

    '71 Ford 3000 Diesel. I have hydraulic leak. Where the high pressure hydraulic line enters the rear housing. While I lift 3pt implement, the leak occurs. When I take the pressure off, the leak stops. I can actually see the hydraulic pipe pushing out from the C7NNH856C Tube Nut. So it has been...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top