Recent content by Ted Lewis

  1. T

    Hydraulics not working

    You were right, not a drop when I open the return. Now to figure out how to get it to prime. Thanks for your help.
  2. T

    Hydraulics not working

    Thanks, I'll give it a try. Have a great day!
  3. T

    Hydraulics not working

    I just put new seals and o-rings in the Hydraulic pump on my Kubota b7100d. I changed the hydraulic fluid but now the arms on the 3-pt will not lift. Is it possible that there is air in the system? If so how do I bleed it out? Thanks for your help.
  4. T

    Kubota B7100 Hydraulic pump rebuild

    Thanks, much appreciated! I can't find a snap ring on the shaft end, is there any other way it could be held in?
  5. T

    Kubota B7100 Hydraulic pump rebuild

    Jim, I have another question related to this you may be able to help with. The bolts which hold on the hydraulic lines in place have holes in them to allow the fluid to pass through. When I snug the bolts down the holes did not perfectly align with the hydraulic lines. There appears to be...
  6. T

    Kubota B7100 Hydraulic pump rebuild

    Thanks for your response. I removed the 6 bolts and took the end plate off which allows me to get at 3 of the O-rings, however the outside bushings are set in firmly. I was afraid to try and pry on them but perhaps that's the solution.
  7. T

    Kubota B7100 Hydraulic pump rebuild

    I was getting Hydraulic fluid in my engine oil and after a little research it looked like the only place this could happen was in the hydraulic pump. I bought the seals and o-rings, pulled the pump but now I don't see any obvious way to remove the outer bushings. Can anyone tell me how to...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top