-
T
Ferguson Wiring Confirmation
Eric, thanks for your comments. I received this tractor second hand and wanted to confirm the original conversion to 12 volt was done correctly. 1. I don t believe the oil pressure gauge is operational, and there is nothing currently going out of the gauge. I put in the drawing for potential...- tekjr3
- Post #4
- Forum: Harry Ferguson
-
T
Ferguson Wiring Confirmation
Hello all, I ve had some issues with my Ferguson tractor, which I believe was a short in the wiring system. Many of the electrical components were getting old, so I decided to replace them. I m looking for some assistance when it comes to the rewiring of this 12v system. I have attached a...- tekjr3
- Thread
- Replies: 6
- Forum: Harry Ferguson
-
T
Ford 641 Oil Inlet Pipe Removal
Hello, I'm looking for some information on how to remove the oil inlet pipe from a Ford 641 or similar. The oil inlet pipe goes down through the head and tucks into the block. I can't remove the head without removing the inlet pipe. Any suggestions on how to remove the pipe from the block? Thanks!- tekjr3
- Thread
- Replies: 2
- Forum: Restoration Processes
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy