-
T
8N Rear Hub
Dean, mine is an early 1948 model. no inside seal. So, do you think my hub will seal with a slight wear groove, or should I get a new hub? Also, I went ahead and tore the whole thing down. Do the 4 through bolts come out to get out the seal retaining plate? They don"t seem to move. How do I get...- Terry 86
- Post #1
- Forum: Ford 9N, 2N & 8N
-
T
8N Rear Hub
I have a wear ring worn in my hub where the seal rides on it. How much wear do you guys think I can get away with? Its not much, but I can feel it with my fingers. The sleeve I'm talking about is a thin tin cylinder that taps on the surface to seal against the seal. I have seen these for...- Terry 86
- Post #1
- Forum: Ford 9N, 2N & 8N
-
T
8N Rear Hub
I have a leaking axle seal and am replacing it. My hub is tight, but has a wear ring against the seal. How much is tolerable, and is there such a thing as a sleeve for this? Also, do I have to remove the plate the seal rests in, or does it go in from the outside? I can"t really tell. Thanks- Terry 86
- Thread
- Replies: 8
- Forum: Ford 9N, 2N & 8N
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy