(800) 853-2651
SHOP NOW

Recent content by thebunns

Yesterday's Tractor Forums
  1. T

    Stuck Clutch

    I just tied the clutch down, put the transmission in 3rd gear, pulled the center coil wire, wrapped a strap around the front axel & dropped it over the ball on the front of my 9N. I backed up about one foot & stopped. I noticed that it & the Farmall rocked back a little. I decided...
  2. T

    Stuck Clutch

    One of you guys was asking how long the tractor had been sitting. I think it has been around 10 years since it was moved. I start it about once a month, like every other engine I have but don't necessarily move it.
  3. T

    Stuck Clutch

    Can I do it in 20 minutes in my mid 80's with a brand new pacemaker?
  4. T

    Stuck Clutch

    Can I gain anything by removing the plate (2 screws) off the front of the bell housing?
  5. T

    Stuck Clutch

    Can somebody think of a way to "unstick" the clutch on my '39 Farmall Cultivator A"? I won't try and start it with it in gear as I might run over the person with the crank.
  6. T

    Breather is Blowing Air

    I was running all five tractors this morning when I noticed the TD-14 making a lot more noise. It was blowing air out of the breather connected to the intake manifold. The weather was nasty so I shut it down & came into the house. Now, in my armchair can I assume that in diesel mode if...
  7. T

    TD-14 Head Gasket

    Here's a pic of a 50675 DD gasket overlayed onto a 50675 DC gasket. It shows why a "D" gasket can replace a "C" gasket, but not the other way around. That's if you don't care about the shape of the holes. The two large holes on the bottom of the "D" gasket are solid on the "C" gasket. Vic
  8. T

    TD-14 Head Gasket

    Here's my "perfection". It is not the -14! When I get done with the crawler, if it runs fine! If not, no big deal. Vic This post was edited by thebunns on 06/01/2021 at 06:20 pm.
  9. T

    TD-14 Head Gasket

    Thanks! I'll have a look at them & determine if replacements are warranted. I may lay a board across the top of the motor & tip the head to have a look at it. I don't care about the valves as they were working when I shut the motor off. I'm not looking for a perfect engine stuck in a...
  10. T

    TD-14 Head Gasket

    I totally agree with you but, my question was: "Do I necessarily need to change them, and if so do they just pop out & in?" Vic
  11. T

    TD-14 Head Gasket

    Thank you, guys. As I am beyond (age wise) lifting tractor heads I plan on winching the head up enough to clear the studs & swapping the gaskets. One more thing, what about the fire rings? Do I necessarily need to change them, and if so do they just pop out & in? Vic
  12. T

    TD-14 Head Gasket

    I need a head gasket (p/n 50675 DC) for my International TD-14. I have a new gasket (p/n 50675 DD) for my TD-14A. What is the difference between the C (-14) & D (-14A) in part numbers? Will the gasket fit the -14?
  13. T

    TD-14 Head Torque

    I came up with a pattern that does exactly what you suggested but don't know how to post it here. Vic[/img:3d0c8dd456]
  14. T

    TD-14 Head Torque

    The torque pattern in the TD-14 service manual is not the correct illustration for head #8064DA on my tractor. It's the right head according to my TC-25-B parts catalog. Can somebody provide me with the correct torque pattern. Vic[/img:2900c8b507]
  15. T

    9N temporary fuel tank

    Here's my concoction! I drilled a hole in the plastic bottle & screwed a barbed fitting smeared with gorilla glue into it. The rest is obvious. Vic [/img:cc4ba1076f]
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top