Recent content by thornapple

  1. T

    730 pony motor

    This message is a reply to an archived post by MBdeere on December 14, 2010 at 15:28:54. The original subject was "730 pony motor". I called Glen and he said they always had a used ones laying around for the motors they rebuild and did not have a source that I could go to. I checked on the...
  2. T

    JD pony motor cam followers

    I am rebuilding a pony motor for a JD 730 using parts from two. They have different style cam followers, push rods, and rocker arms. I want to use the newer style in the engine I am rebuilding which originally had the smaller push rods. The mechanic who ground the valves told me I cannot...
  3. T

    jd 430 clutch alignment tool

    That worked fine. I do have and engine lathe and Ijust machined the double step spline diameters and the pilot diameter on an old piece of round stock I had laying around. I never thought about not needing the spine. Thanks for the tip. Tom
  4. T

    jd 430 clutch alignment tool

    I just found out that the clutch disc in my 430 jd has a 17 tooth spine measuring 1 and 1/8 inches in diameter. The tool I purchased from Yesterdays Tractors is for a 10 tooth spine measuring 1 and 3/8 inches in diameter. I ordered the tool before I split the tractor not knowing that jd used...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top