(800) 853-2651
SHOP NOW

Recent content by Tim Berglund

Yesterday's Tractor Forums
  1. T

    John Deere 45 S/N 49446-H Separator clutch spring

    I bought this combine and it did not have a separator clutch pulley return spring to keep the tensioner pulley away from the belts when declutched. I found the correct spring but for the life of my I can't tell where it goes. Perhaps there is something else missing. The new spring is only about...
  2. T

    JD 45 combine return spring

    I have a late production 45 square back s/n above 49000. It does not have a return spring to move the separator drive belt engagement pulley to the disengaged position which does not allow the separator belts to completely disengage. I can not find a picture in the operator manual of how the...
  3. T

    45 squareback parts needed

    I need the same plates. Did you find any? Do you have any??
  4. T

    1968 JD 45 radiator

    The tubes in the core are split lengthwise because the overflow tube rusted shut. Siince the pressures could not escape through the tube when the cap vented the radiator over pressured and split every tube at both the top and bottom of the core. It is unrepairable according to the shops I have...
  5. T

    JD 55 vibration

    Sounds like you have done all the obvious repair. If you have not replaced the chopper belt you might give it a close inspection. If the chopper had ever become clogged and stuck in the past it is possible that the drive pulley continued to turn on one spot of the belt before it was shut down...
  6. T

    Radiator for 45 combine,

    I need a good radiator for a 1968 JD 45 combine with a 180 cu in 51HA gasoline engine. The radiator has two numbers on a plate soldered to it. The numbers are 1AH6308 and either AH6308 or AH6508. There is a scratch through the 3 or 5 making it hard to verify that number. The combine S/N is (45-...
  7. T

    1968 JD 45 radiator

    I need a good radiator for a 1968 JD 45 combine with a 180 cu in 51HA gasoline engine. The radiator has two numbers on a plate soldered to it. The numbers are 1AH6308 and either AH6308 or AH6508. There is a scratch through the 3 or 5 making it hard to verify that number. The combine S/N is (45-...
  8. T

    John Deere 3300 combine

    I have a nice 1970 JD 3300 combine with a 12' grain head and "pick-up" reel, located 50 miles south of Kansas City. Please phone my cell at 620-951-0568 if you are interested. This is my work e-mail so if you respond by e-mail I will not get your message until next Monday. Regards, Tim
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top