JD 55 vibration

I need some suggestions. When I run the combine with the chopper belt off it is ok. When I put the belt on it starts vibrating at about 1400 rpm on the engine tach. When it is full throttle the whole machine shakes and even the cab rattles. I put new hammers and bearings in the chopper and had it balanced. I replaced the bearings in the drive where it has the chain sprocket on one side and the pulley on the other and I added another idler pulley to the belt. I am about to pull out the last two hairs I have left. Any thoughts?
 
What kinda shape is the chopper belt in? And I might ask about the chain and sprockets on the drive and if the drive chain is real loose or not. It maybe jumping teeth on the sprockets. You may want to check the bearings on that main shaft that they are not going bad.

I know this may sound dumb but did you clean the cylinder out last year? With the cab viberating that bad it could be the cylinder out of balance dew to dust settling and getting hard on one side of the cylinder over the winter and spring. Just a few things to check that might be the problem. Bandit
 
Hey Bandit, The chopper belt is almost like new. I did not check the main shaft bearings. I guess that would be a good place to start. The chain seems tight enough and the sprocket teeth are good. I will check the cylinder for dust. I just don't understand why it is worse with the chopper spinning when all of that has been replaced. Could it put more load on the seperator?
 
Sounds like you have done all the obvious repair.

If you have not replaced the chopper belt you might give it a close inspection. If the chopper had ever become clogged and stuck in the past it is possible that the drive pulley continued to turn on one spot of the belt before it was shut down. I have seen belt develop a hard spot where in this area due to the excessive heat build up. this portion of the belt then does not bend and flow through the pulleys the same as the rest of the belt. Every time this hard section passes over the pulleys it is similar to a short piece of 2x4 board trying to go around in a circle. This can cause so much vibration that the sheet metal on the combine can be seen moving in and out several inches. Hope this helps.
 
Also check the drive pulley. That shaft may be bent
and the vibration only shows up with the belt on.
It's also possible they screwed up the balance of
the chopper. wouldn't be the first time a mistake
was made.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top