(800) 853-2651
SHOP NOW

Recent content by Tim in NY

Yesterday's Tractor Forums
  1. T

    rock shaft for B Allis

    OK I had to go look... The mounts are at about the same width but the overall length of the C rockshaft is much longer.
  2. T

    C drawbar

    I have a couple C drawbars available. Thanks, Tim
  3. T

    rock shaft for B Allis

    The rockshaft for a B is shorter than a C, due to the fact that the C rearend is wider. I have a few of both available. Thanks, Tim
  4. T

    AC B Cultivator

    Ed, I have a couple round shank spring trip assemblies that I'll sell. I can send you pictures of them if you are interested. Thanks, Tim
  5. T

    2-way plow for a B

    I have A couple right and left hand plows, as well as a drawbar for the B and a depth conrol lever. I'm south of Albany, NY
  6. T

    WD45 diesel engine to bellhousing plate

    Hi Matt, Sorry I haven't responded sooner, I just came back from a little vacation. I'll give you a call about the plate tomorrow (sat) Thanks, Tim
  7. T

    WD45 diesel engine to bellhousing plate

    Sorry for the delay in responding, I was away this past week. I do have a double groove pulley but it is off of a Gleaner E power unit. It will fit a D17,wd/wd45 crank, not sure about others. It is available if you are interested. Thanks, Tim
  8. T

    WD45 diesel engine to bellhousing plate

    I have a WD45D plate that I'll sell. Would take $100 plus shipping for it. Email if interested.Thanks, Tim
  9. T

    1937 WC Unstyled

    I have a complete engine out of an unstyled WC, it turns over and was full of coolant but that's all I know about it. Would take $100.00, but I'm in NY. Thanks, Tim
  10. T

    G226 Starter Interchange

    I have a good starter that came with a complete Gleaner E power unit. I'm going to put the engine in a WD45 so I don't need the starter. Email if you are interested, I'll sell it for a reasonable price. Thanks, Tim
  11. T

    Allis Chalmers RC thermostat housing radiator

    Overall Height is 6.5". Height to the top of pipe (where rad hose connects)is 5 3/16" bolt spacing is 2 3/8" I have one complete running RC and another project tractor... both have this same manifold.
  12. T

    Allis Chalmers RC thermostat housing radiator

    I have the thermostat housing listed on ebay. I do have a radiator for an RC also that I may be talked into selling, but it would mean committing to parting out a fence row RC that I thought I"d restore someday. I"ll give it some thought!
  13. T

    Can you make an Allis CA a flat back?

    I have a delete cover on my CA puller. There was one on ebay recently
  14. T

    WD PTO gear

    Tony, to get to the PTO drive gear you will need to split the tractor behind the hand clutch. Make sure you support everything properly! I have a couple drive gears available if you need one. Thanks, Tim
  15. T

    WD wide front

    I have a good four bolt wide frontend that I'll sell complete with the gear box. If interested email me. Located near Albany, NY
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top