Recent content by Tim OOO

  1. T

    8n flywheel

    From the rings gears I have had (all 3), one side is beveled and one side is not. If the ring gear is bad, best to buy a new one.
  2. T

    8n clutch trouble

    Just a thought but if its just the play couldn't you shorten the rod that goes into your clevis? Use a die and put some new threads on it? (shorting the rod will take the slack out of the linkage) Maybe that threaded rod was replaced at one point? No, because the foot pedal arm will bind on...
  3. T

    9N will not start

    You could try and take the wires off the switch and put them together bypassing the switch and then try rolling over with the starter button. Though you tested continuity and there was nothing, sounds like a bad switch.
  4. T

    8n clutch trouble

    Thanks for the answers. I did put the old pressure plate and clutch back in and the clutch works again, but I still have alot of play in the pedal. I will not be able to put a longer bolt in for adjustment as the 8n clevis type adjustment will not allow for it. The clucth and pressure plate...
  5. T

    8n clutch trouble

    Hi, I am repowering my 8n with a 9n engine. The engine has a newer clutch and pressure plate. I installed the engine and have lots of slop in the clutch pedal. There is about 4 inches of travel (In the pedal) before the release bearing makes contact with the clutch fingers. I did check the...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top