(800) 853-2651
SHOP NOW

Recent content by TimAP

Yesterday's Tractor Forums
  1. T

    4010 High Oitch Steering Noise

    Sorry, Meant HIGH PITCH
  2. T

    4010 High Oitch Steering Noise

    Hi, I just purchased a 1962, 4010 with 3000 hours and all seems in fair condition (so far) except the steering makes a really high pitch sound/noise. At right, left or not moving steering at all, the noise doesn't change hardly any, the steering works well but more of a very high irritant than...
  3. T

    Z134 Knock

  4. T

    Z134 Knock

    I the back of my old mind, something tells me its in the valve train, can something in there cause a loud knock, I had cars with bad crank bearing and this seem different, its not that loud thump type knock, its loud but a little higher pitched... Tim
  5. T

    Z134 Knock

    I have all my scribbling down somewhere, wife likes to come into shop and say,,,,can I throw this, can I throw this, can I throw this, she means well but aggravates the s..t out of me...but I think I have the paper in tool box.. I'll be back.. Tim
  6. T

    Z134 Knock

    I will try this today, hope before it gets to hot. Now have start solenoid out of lawn tractor, someone else pulled it out for me, now I see about 7 wires hanging loose,Hey buddy, were do these wires go, I Dont Know.. Geeesss Anyway, On the Z134, Could it possible be a problem in the valve...
  7. T

    Z134 Knock

    Well Bob, I cant remember the readings but plastigauged the crank every 1/3rd rotation and remember looking at the min. and min. and showed it was OK in the book.. But, that really doesnt mean its ok I guess.. Tim
  8. T

    Z134 Knock

    I think I plasti gauge them and were ok, I f I remember right, but it missing also.
  9. T

    Z134 Knock

    Hi Guys, last year about this time I had a small knock in the engine, so put in a new set of rod bearings, nothing changed, still had that little knock. Now its getting louder and notice engine is missing. Had rocker cover off and could not pin point where the noise is coming from, checked and...
  10. T

    1956-TO35 Rear Axle Difference

    I have an axle for my tractor but see a difference, old axle has 6 bolt retainer, new one 12 bolt retainer but every other bolt on this one is the same distance apart as the 6 bolt. Seems like it will work, bearings and seals seem good so do you think I could just put the new one in. Thanks, Tim
  11. T

    1956-TO35 Trans Dipstick

    Thanks for the info, I might have always been a little short on oil but now I know the exact level. Thanks, Tim
  12. T

    1956-TO35 Trans Dipstick

    Opps, better post pic I guess <image src="http://forums.yesterdaystractors.com/photos/mvphoto4728.jpg"/>
  13. T

    1956-TO35 Trans Dipstick

    While digging around in the transmission with my fingers while washing everything out with diesel, I felt something and it was part of a dipstick, the original Im sure because the one in the tractor since my purchase was the other. Would anyone know what the correct length is and from what spot...
  14. T

    1956-TO35 Rear Axle Snap-No Go

    Bob. I did check that area first and found everything we good in there. Thanks Tim
  15. T

    1956-TO35 Rear Axle Snap-No Go

    I think your right. Going to be a SOB manhandling that other fluid filled tire. Need to borrow somebody's cherry picker for that one. Thanks for the help. Tim
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top