(800) 853-2651
SHOP NOW

Recent content by Timber oak16

Yesterday's Tractor Forums
  1. T

    jd 110

    The 1963 tractors were 2550 to 3550 for serial number. Yours being 20197 is a 1965 , in 1965 they were between 15001 and 40000 serial number
  2. T

    crosen equipment any information please

    Your interest in Crosen Equipment, I believe this was a John Deere Industrial Dealer in Hartford, Ct. during the early 1960's. At that time they had very few straight Industrial dealers, as most dealer sold both the Ag and Ind line, L&G started later and still later they seperated the Ag & Ind...
  3. T

    unknown Briggs and stratton

    Go to NAPA, they sell a special wrench for the starter clutch, I bought one, works good. NAPA Number 7-05222
  4. T

    Crank no start, no fuel DTY 4000 24hp v twin kolher

    I had one with the same problem, found the battery was hooked up backwards, starter would spin and engine would run on fuel put into carburetor, This one someone had the battery off to replace spark plugs and installed it backwards, with the battery backwards it closes the electrical shut off...
  5. T

    Unknown JD implement

    You have a hay fluffer #2 or #3, the wheels acted as a brake to make the reel turn just a little slower that ground speed. The hay from the swath (not raked) would drive the reel and would lift the hay. Worked real good in light hay when you didn't need it, would slide the wheels in heavy hay...
  6. T

    145H plow settings

    Sounds like the plow is not level(parallel with the ground surface), try lenthening the left lift link and/or shorten the right lift link. This plow should run level, not tipped to the right. we use the term level to mean parallel to the ground surface. The longer the plow the more this show...
  7. T

    John Deere 400 dies after about 30 minutes

    Many years ago while working at a John Deere dealership we had a 400 L & G that would do the same thing, run fine until it got hot, we replaced everything in the engine electrical system, still had the problem, turned out to be the key switch, replaced the switch, corrected the problem Good...
  8. T

    John Deere 170 mower

    No. It is just a lawn tractor with front snow removal equipment available for it
  9. T

    Troy bilt tomahawk chipper

    Was just given a Super Tomahawk II (Troy bilt) model 10639 chipper. Does anyone know the proper length for the belt, I know it is a 5/8" wide belt/ Thanks for any help
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top