(800) 853-2651
SHOP NOW

Recent content by TJ64

Yesterday's Tractor Forums
  1. T

    Front wheels

    That is what I did to the other side. took an angle grinder and then wire wheel to it. Rust primer,and a rubber strip around the middle of the rim. Guess I'll have to do it to this side as well. Not sure I have the right tube in this one. The tire I took off (U.S. Royal) wasn't on there properly...
  2. T

    Front wheels

    yes, dishsoap, a maul, working it on with a tire spoon. On and off 3 or 4 times now.
  3. T

    wide front tires

    Where are you finding 6.00-16's for $130 a pair? Best prices I'm finding are $109 each for tri ribs.
  4. T

    Front wheels

    My tire guy gave me a new set of tires.(NOS , some checking from sitting outside) One side will NOT come up on bead in a small section. I've tried everything and no-go. The old tire was the same...too far up on one side and not seated opposite. I hope I don't have a rim issue now
  5. T

    Front wheels

    I'm trying to get by for a few more months on these old nasty tires on the front. I had a flat, aired it up and hauled a couple logs. Parked it for an hour and went out to get it again and the tire was flat again. I broke down the tire, the rim is nasty! I wire brushed it, chipped it with my...
  6. T

    Primary seal etc.....

    I buy some here. I don't do so blindly though, I don't remember what it was that I was looking at a while back but there was a $45.00 difference between here and another vendor. (Wasn't Steiner either)
  7. T

    Primary seal etc.....

    Yeah! That is the one they sent me from Steiner. A straight thru bolt design like your pic is pretty straight forward. That is what it looks like in the book, but not what I got. Thanks again! Tom
  8. T

    Primary seal etc.....

    Both ends are a stud.... different type.
  9. T

    Primary seal etc.....

  10. T

    Primary seal etc.....

    Appreciated! I have the new style, but I think I will guess too from bottom.
  11. T

    Primary seal etc.....

    Months ago I purchased a new primary conductor and insulator/seal my machine never had one when I bought it. I just wanted it back to original. Have read since that many would rather just use a grommet to seal the opening on the distributor. My ask is this: can anyone take a picture of the...
  12. T

    8N refuses to start all of a sudden

    Around here that is 2-3 days.. .only because of rain. I need another one, cuz I can't afford to have it down to fix things, lol.
  13. T

    hydraulics and 3 point

    I was curious about that. Directions said to adjust draft control first and then position control......so I did! Position control works better than it did before, but I have to think the new piston and cylinder have a lot to do with that :) . Thanx again, John!
  14. T

    hydraulics and 3 point

    Ahhh! It was working fine (at least it was staying in position) before I replaced the cylinder and piston. I'm wondering if I back off the big spring a half turn or so? The instructions that came with the Zane Thang didn't sound the same as what I previously read or saw in the J&D video. The...
  15. T

    Gearlube

    Tractor had a gallon of 80-90 still in it so that is what I added. I will change it again before September. At that time I will wash it all out with diesel or mineral spirits and fill with UTF. Thank you for your insights.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top